Quick Start Manual

Editing Amp, Cab & Mic Parameters
WhenanAmpBlockisselected,youcanusetheMulti-functionknobs
1-4toselectAmp,Cabinet,orMicModels.Whenusingadualamp
setup,Knob4allowsyoutoassignwhichampgetscontrolledbythe
DRIVE, VOLUME, and TONE knobs.
Amp Block OFF
A
B
Turn any of the Amp Tone knobs to adjust the desired settings for the
selected Amp.
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
SAVE
HOLD FOR SYSTEM & I/O
VIEW
P
R
E
S
E
T
S
Whenever you adjust any of the Amp Tone knobs, you’ll see the
“Momentary”AMP: EDIT LCD screen temporarily displayed, showing the
actualvaluesoftheToneknobsforbothcurrentAmpA&AmpBModels.
Or, to manually display the AMP:EDIT screens, double-press the ENTER
buttonwhenanAmpModelisselected.You’llseethescreen’srespective
controls adjust as you adjust the DRIVE, VOLUME, and TONE knobs.
The black “dots” around each knob indicate its last-saved value. With an
AmpBlockoyou’llseeonlyaVOLknob.Thisisaseparateparameter
strictly for the Amp Model’s Bypass Volume. Use the VOLUME knob
on your device to adjust this, and its value is stored separately with the
Preset for whenever the Amp Block is Bypassed.
YoucanusetheAmpModeldeepeditparameterstocompletelychange
the behavior of any amp model from subtle to extreme. It's like having your
very own amp techinician by your side. From page 1 of the AMP:EDIT
screen, press the 4 Way Nav Pad right arrow button to view page 2.
Knob 1 - MASTERsetstheamountofpowerampdistortion.Thispa-
rameter is highly interactive with all deep edit parameters.
Knob 2 - SetstheamountofSAGinthepoweramp.Athighersettings
the model becomes "squishy" with more touch sensitivity and improved
sustain.
Knob 3 - Controls how much heater hum and AC ripple interacts with
your tone. At maximum setting things get really freaky - you've been
warned.
Knob 4 - Sets the Multi-Function knobs to alter the settings on this
page for Amp A or Amp B.
Press the 4 Way Nav Pad right arrow button again to view page 3.
Knob 1 - Adjusts the bias of the power tubes. At maximum the amp is op-
erating in Class A. Set to minimum you get a very "cold" Class AB biasing.
Knob 2 - Bias Excursion is a phenomenon that occurs only as the
power tubes are pushed. Set low for a tighter feel. Set high for more
tube compression (Note: Turn DRIVE&MASTERuptoexperiencethis
phenomenon).
Knob 4 - Sets the Multi-Function knobs to alter the settings on this
page for Amp A or Amp B.
Press the 4 Way Nav Pad right arrow button one more time to view page 4.
Knob 1 - Sets the amount of "early reflections." Higher settings add more
reflective room sound to your tone.
Knob 2 - Turn to change Cabinet Models .
Knob 3 - Selects Microphone type.