Owner's Manual

POD Farm 2 Advanced User Guide – Using Your Line 6 Hardware
2•4
UX1
Connect a microphone
Connect your electric guitar or bass
Connect your stereo headphones
Mic Input - Connect a microphone here using an XLR cable. This feeds the microphone signal
into the POD Farm 2 standalone application where you can choose your Tone, and then route the
processed signal to the Record Sends (to your audio software) and your ToneDirect™ monitoring
signal to the hardware outputs. Note that UX1 does not offer “phantom power” - if your microphone
requires phantom power then you will need to use an external power source to provide it.
Instrument Input - Plug in your electric guitar or bass here to feed the instrument’s signal into the
POD Farm 2 standalone application. This allows you to choose your Tone, and then route the processed
signal to the Record Sends (to your audio software) and your ToneDirect™ monitoring signal to the
hardware outputs.
Phones - To listen using stereo headphones, plug them into this 1/4-inch stereo jack. This headphone
jack outputs the same signal fed to the Analog Outs - The audio from your audio software on the
computer, as well as anything plugged into any UX1 input.
Connect any line level input
source that you want to record
into the Line Inputs
Connect any line level input
source for monitoring to the Stereo
Monitor In
Connect a USB cable from here to
your computer’s USB port
Connect the Analog Outs
to your audio monitors
Line Inputs - To record the signal from a line level source, such as a keyboard, your stereo receiver, the
line out from a mixing console, etc., connect to these Left and Right ins using 1/4 inch audio cables.