Owner's Manual

POD Farm 2 Advanced User Guide – Using Your Line 6 Hardware
2•7
UX8
TonePort UX8 is a multichannel recording interface designed for professional use, offering plenty
of headroom, a wide dynamic range and an exceedingly low noise floor. Designed with high quality
electrical components and a rugged exterior, UX8 is built to provide many years of reliability.
UX8 can be used with the POD Farm 2 Plug-In or POD Farm 2 in standalone operation, providing
you with the same POD quality Tone trusted by scores of platinum-selling musicians and recording
engineers!
Rear Panel Features
Balanced Outputs
UX8 provides 8 balanced analog outputs (4 stereo pairs). For the cleanest audio signal, use 1/4-inch
TRS cables to connect directly to your powered speakers, mixer or power amp setup. Note that you can
use each output pair to provide different monitor mixes for musicians during a tracking session. You
can set the input mix levels for each output pair using the Line 6 Audio-MIDI Devices application.
S/PDIF Digital Audio
To send or receive S/PDIF, connect a 75-Ohm coaxial cable to the UX8 RCA jacks and the external
S/PDIF device. This is the best choice for connecting to digital recording devices, such as a DAT
recorder, digital mixing console, etc. This S/PDIF output sends the same audio as Main Outs 1-2. The
digital signal is always received and sent at 24 bit. To sync to an external S/PDIF device, set the UX8
clock to sync to S/PDIF in the Line 6 Audio-MIDI Devices application.