Owner's Manual

POD Farm 2 Advanced User Guide – Using Your Line 6 Hardware
2•27
PODxt Pro
Instrument Input -
Connect your guitar or bass
Phones - Connect
your stereo
Headphones
Instrument input – Connect your electric guitar or bass here using a standard 1/4-inch instrument
cable. PODxt Pro itself contains the processing power that turns your naked input signal into that
roaring guitar Tone, which is then fed out the Analog and Digital Outs, as well as fed to the Record
Send 1-2 digitally to your computer across the USB connection.
Phones - If you want to listen to your audio using stereo headphones, then plug them into this 1/4 inch
stereo jack. This Headphone jack outputs the same signal fed to the Analog Line Outs - The audio
from your audio software on the computer, as well as anything plugged into the Instrument input.
Connect any Line-Level
source you want to
record to the Line Input
Unprocessed Instrument Out - When
using POD Farm 2 Plug-in, connect to
3rd-party audio recording interface
USB - Connect to
your computer
Analog Line Outs - Use either Unbalanced
(¼ -inch) jacks or Balanced (XLR) jacks to
connect to your powered speakers or mixer
Digital Input and Output - Use the AES/EBU
or S/PDIF type connections to connect to other
digital gear that uses one of these formats
Line Input - To record the signal from a line level source, such as a keyboard, your receiver, the line
out from a mixing console, etc., connect it to this input using a 1/4 inch audio cable.
Unprocessed Guitar Out - This connection allows you to send an unprocessed, analog signal to your
DAW setup, while monitoring the fully processed signal thru the main outputs. Very handy if you’re
using a 3rd-party recording interface (such as a Digidesign Mbox
®
) with your recording application
and the optional “POD Farm™ 2 Plug-In”. For more info, see the “ToneDirect™ Monitoring” section.
TIP: PODxt Pro can also send an unprocessed signal to your DAW via USB audio, as explained in “PODxt
- Audio Signal Routing & Re-Amping”
.