Owner's Manual

POD Farm 2 Advanced User Guide - POD Farm 2 Plug-In
4•10
Mouse cursor indicates the Preamp
model being dragged cannot be
dropped.
White arrows indicate the legal
position where the Preamp can be
inserted
White arrows indicate the legal drop location for a dragged model
• Model Replacement indicator in SFV - A Tone path cannot exceed its maximum model
capacity (one each max. for Amp, Cab & Preamp models, and ten total effects models max.
for each Tone path). Therefore, if dragging a new model into a Tone path where a maximum
model count exists, the new model must replace an existing model. In this scenario, the
model to be replaced is indicated with a “ghost” image when dragging over it, as shown here:
A “ghost” image indicates the existing Amp or Effects model is to be replaced by the one being dragged into the Tone path
Scroll Bar
Click and drag left or right to browse through models - or use your mouse wheel!
Panel View
The Panel View provides a close-up view of the selected model and overall control of its available
parameters. To access the Panel View for any Amp, Cab or Effect model, click the Panel View button
on the Main Control Bar, then click on the desired item within the Signal Flow View. Or, if the Panel
View is not currently displayed, double-click any model within the Signal Flow View.
Amp View
Once you’ve selected a guitar amp or bass amp model within the Signal Flow View, double-click on
its icon in the SFV to display its controls in the Panel View (or, if the Panel View is already the View
displayed, a single click on the SFV Amp model icon will display its controls). Here you can choose to
display the Amp or Speaker Cabinet/Mic options.