manual

Spider Jam the Amp
2•4
Spider Jam the Amp
Microphone Trim Knob
Therststepafterconnectingamicrophoneistosetthisknob:
•Sing into your microphone at maximum volume and turn this knob until the Clip light starts to light
slightly.
•Turntheknobbackdownslightlysoclippingwon’toccur.
•Whennotusingamic,alwaysturnsthisallthewayleft(clockwise)tominimumtoavoidanynoisefrom
the unconnected mic preamp.
Microphone, Aux, and CD/MP3 Input Levels
Before using the Mic, Aux and CD/MP3 inputs, set their levels as follows:
•Press the
Level / Inputs button twice to show this display:
•Press Left/Right on the 4-way button to select Mic, Aux, or CD.
•Sing or play into the selected input and observe the readings on the meter.
•Adjustthe
Selectknobsothatthemetershowsapeakreadingbetween-20and0.
Tip: Start by turning the
Selectknobuntilyousee+0dBonthe screen(asshown intheprevious
graphic). Then, turn whatever is connected to Spider Jam up or down to get a peak meter reading
between-20and0.Ifyoucan’tgettherefromtheotherunit,usethe
Select knob as described above.
Mic/Aux EQ
Ifyou’dliketocustomizetheMic/AuxEQyourself:
•Press the Tone / Settings button three times to show additional functions.
•Turn the
Select knob to highlight Mic/Aux EQ.
•Press
Right on the 4-way button.
•Press
Left/Right on the 4-way button to select Bass, Mid, or Treble.
•Turn the
Select knob to adjust the Bass, Mid, or Treble levels.
BASS TREBLEMID