® XD-V35 Digital Wireless Pilot’s Handbook Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 取扱説明書 40-00-0335 also available @ www.line6.
Important Safety Instructions C A UT I O N RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CERTIFICATION THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
You should read these Important Safety Instructions. Keep these instructions in a safe place Before using your XD-V35 Digital Wireless System, carefully read the applicable items of these operating instructions and the safety suggestions. 1. Obey all warnings in the XD-V35 manual. 2. Do not perform service operations beyond those described in the XD-V35 Manual.
Thank you for your purchase of the XD-V35 wireless microphone system. It is a high quality digital wireless system, in a simple format that is virtually plug-and-play. With its fully digital transmission, the system provides features and benefits that differ in some ways from previous generations of analog wireless, but in most respects you use it just like other wireless systems.
XD-V35 Digital Wireless Quick Setup Receiver 1 2 3 trans status 4 5 audio 2.4GHz DIGITAL WIRELESS SYSTEM XDpower CHANNEL UNBALANCED OUT BAL OUT RXT06 RECEIVER + 9Vdc 200mA 6 7 8 1. 6-Position Channel Select Knob 2. Battery Level Indicator LEDs – Lights green, with all lit indicating full transmitter battery; bottom LED turns red when 1 hour remains, and flashes red when less than 40 minutes remain. 3.
Bodypack Transmitter 3 1 2 6 4 5 1. Audio LED – Green when audio signal present 2. Battery Level LED – Blue with good level, red when low, flashing red when less than 40 minutes remain 3. On / Off Slide Switch 4. Channel Select Slide Switch 5. Quarter-Inch (1/4”) TRS Input Connector 6. Battery Door Slide switch and hinged door. Open the battery door on the side of the bodypack and insert two AA batteries. Slide the On/Off switch to turn on.
SELECT CHANNEL Handheld Transmitter AA BATTERY 1. Power Button – Press briefly to turn on; press and hold for two seconds to turn off 2. Channel Select Button – Channels 1 – 6 3. Channel LEDs – Lights blue to show current active transmission channel; Channel 6 LED illuminates red when battery life is low, and blinks red when less than 40 minutes remain. Unscrew the transmitter base and insert two AA batteries. Push the On button to turn on.
the receiver has no gain or attenuation controls. Do not use TRS connectors with the XDV35 Receiver as the Ring portion of the connector is used for firmware updates and may cause computer generated noise in your audio outputs. Note: When the associated transmitter is off, and moderate to strong interfering frequencies not coming from a Line 6 transmitter are present on the selected receiver channel, one or more of the RF LEDs on the right side of Trans Status will turn red.
Status LEDs will light green, and when you speak in the mic the receiver Audio LED will light green. Connecting the XD-V35 Receiver The receiver features a balanced XLR and unbalanced (tip-sleeve) quarter-inch connector. To connect to a mixing board or powered mixer, use a microphone cable between the receiver output and the mixer’s mic-level input – in the same way as you would connect a wired microphone.
APPENDICES Troubleshooting Problem Solution No Audio Transmitter off or battery out of power Batteries put into transmitter out of polarity Transmitter and receiver on different channels Receiver off / unplugged or not connected Can’t Turn Off Transmitter Change Channels Transmitter in locked mode (THH06 handheld only) Loss of Signal Dropouts Shorter Range Distance between transmitter and receiver is too great. Other transmitting or RF devices are too close to the receivers.
XD-V35 Digital Wireless System Specifications System Frequency Band 2.4GHz ISM Band Compatible Channels 6 Spatial Diversity with Digital Buffering Yes Frequency Diversity Yes (2 Frequencies per channel) Compander-Free Design Yes Frequency Response THD % 10 Hz (-0.5 dB) - 20kHz (-2.5 dB) 0.03% typical System Latency < 3.