User Manual

System Setup
2•7
Page 5, Setup: Digital Output Options
Theseoptionsarestrictlyforconguringthesignalfedtothe24-bitdigitaloutputs(S/
PDIF or AES/EBU). All settings are global. When connecting to another digital device,
it is best to clock the external device to follow POD HD Pro (with POD HD Pro as
the “master” device) to maintain proper synchronization - please see your digital device’s
documentation for its digital clock features.
Note: The AES/EBU - L6 LINK output is an XLR jack that can be used for either type
of connection (also see “Page 8, Setup: L6 LINK Audio” on page 2•11). The AES/EBU
options in this screen apply only the AES/EBU output and do not affect the L6 LINK audio
signal when connected to a Line 6 DT Series amplifier.
• Digital Output (Knob 1): Selects the type of output mode signal.
• Match Outputs: Uses the setting as configured on the Setup:Outputs screen - see
page 2•5.
• Dry Input: Your Source Input signal with no Amp, Cab, Mic, “E.R.” or FX
processing applied. (Handy for recording a dry signal in your DAW, to which you
can add a Plug-In or “re-amp” later!)
• Sample Rate (Knob 2):Selectsthesamplerate:44.1kHz,48kHz,88.2kHzor96kHz.
When connecting to another device’s S/PDIF or AES/EBU input, always be sure to
set both units to utilize the same sample rate.
• Digital Level (Knob 3): Increases the amplitude of the S/PDIF or AES/EBU signal:
0dBto+12dB.
• Digital Format (Knob 4): Choose between settings for the S/PDIF or AES/EBU
digital outputs.