User Manual

Amp, Cab & Mic Models
6•3
With the Amp in Post as shown above, the parallel Paths A & B are fed into the input
of the Amp.* You can still move FX into either Path A or B, in which case they’ll be in
parallel, with each Path’s output individually controlled by the Mixer’s A & B Level and
Pan options to allow you to custom blend them before they hit the Amp.
*Note: All Amps & Preamps behave as “mono” Models, which impact the stereo output
of any FX Models positioned before them within the signal flow. For more info, please see
“Model Types and Mono/Stereo Signal Routing” on page 3•6.
Selecting Amp, Cab & Mic Models
Press the VIEW button to display the Signal Flow View and use the Nav. Pad to select
Amp A or Amp B.
The Signal Flow View - Amp B selected
Once an Amp Model is selected, you’ll see the 4 editable Amp options at the bottom of
the screen, accessible via the Multi-function knobs 1 - 4.
• Knob 1 - Selects the Amp or Preamp Model.
• Knob 2 - Selects the Cab Model.
• Knob 3 - Selects the Mic Model.
• Knob 4 - When the current Preset includes two Amp models, this selects which
Amp (the Amp within Path A or B) is controlled by the Amp Tone knobs.
As you change the Amp Model (Knob 1), you’ll also see that default Cab and Mic models
are automatically selected for each Amp or Preamp (see “About Default Amp Settings” on
page 6•5). But you can use Knobs 3 & 4 to select any Cab and/or Mic you like. These settings
are saved per Preset.