User Manual

Amp, Cab & Mic Models
6•6
To adjust the Amp Tone
Turn any of the Amp Tone knobs to adjust the desired settings for the selected Amp.
The Amp Tone knobs: DRIVE, VOLUME, BASS, MID, TREBLE and PRESENCE
Whenever you adjust any of the Amp Tone knobs, you’ll see the “Momentary” AMP:
EDIT LCD screen temporarily displayed, showing the actual values of the Tone knobs for
both current Amp A & Amp B Models (depending on your Amp Knobs Display setting,
see “Page 1, Setup:Utilities Options” on page 2•2). Also see the next section for more
about the AMP: EDIT options.
Amp Edit Display
Double-press the ENTER button to access the AMP:EDIT screens. You’ll see up to 4 pages
of options here, allowing you to fine-tune Amp, Cab and Mic settings.* All settings in
these screens are saved per Preset.
* NOTE: When the selected Amp Model is a “full” Amp Model, you will see four Amp Edit
pages, as described below. When the selected Amp Model is a Preamp, you will see only two
Amp Edit pages, which offer the same options as the Amp Edit page 1 and page 4 described
below. Use the Nav. Disc left & right arrow buttons to display the pages.
Amp Edit - Page 1
ENTER
DBL PRESS TO ASSIGN CTL
MOVE
AMP & FX ON / OFF
Page 1 of the Amp:Edit Screen - both Amps are On