User Manual

ManualsBrandsLine6 ManualsAccessories for Wireless SystemsXD AD8 Antenna Distribution Unit - DISTRIBUTION SYSTEM / SPLITTER FOR RADIOMICROPHONES 2 IN - 8 OUT

Xd-Ad8 QuiCk Setup

9 10

2 3

ANTENNA A ANTENNA B

1 2 3 4 21 3 4

65 7 8

90 - 250V

50 - 60Hz

10 W Max.

DC OUTS

9V 4 Amps

1. Front Antenna B BNC connector

2. Antenna Select –

Switch from front or back pair

3. Power – Toggle switch and LED

4. Front Antenna A BNC connector

5. Rear Antenna A BNC connector

6. Antenna A Distribution Connectors –

Eight BNC distribution connectors for Antenna A

7. Antenna B Distribution Connectors – Eight BNC distribution connectors for Antenna B

8. Rear Antenna B BNC connector

9. 9v DC Power –

Two output connectors to power receivers (use supplied cables)

10. IEC Power Connector – Use a grounded 3-prong IEC power cable (powers the XD-AD8)

•Connect the XD-AD8 antenna distribution system to a power source, 90 – 260 VAC, 50 – 60

Hz.

•Attach one end of the supplied receiver power distribution cables to the

9v DC Power

connectors on the rear panel of the XD-AD8, and plug the remaining barrel connectors into

up to four Line 6 receivers; repeat with the second supplied cable for up to four more receivers.

•Using 50 ohm BNC-to-BNC cables, connect the rear panel

Antenna A and Antenna B

Distribution Connectors – beginning with the connectors labeled “1” – to the Antenna A and

Antenna B inputs of up to eight Line 6 receivers.

•Attach Line 6 rubber duck, directional or omnidirectional remote antennas to the rear

panel

In A and In B BNC connectors, and place them in line-of-sight with the area(s) where

transmitters will be used.

•Connect supplied 50 ohm terminators to any unused

Antenna A and Antenna B distribution

connectors.

•Move the front-panel

Antenna Select slide switch to Back; alternately, use the front panel

connectors for the antennas and move the switch to Front.

•Turn on the antenna distribution system

Power, and check that it and all connected receivers

and antennas are receiving power.

•Turn on the transmitters in the performing area, and check for coverage and that all receivers

have signal from the transmitters; reposition antennas as necessary.

Note, The antenna distribution system and above setup procedure is typically used for rack-mounted

wireless systems, in either a ﬁxed or portable application.

Note, The XD-AD8 antenna distribution system is for use with XD-V75, XD-V55, and XD-V70 digital

wireless microphone systems, and the Relay G50, Relay G55 or Relay G90 digital wireless guitar system.