User Manual

1. Power - Switch on the power with this rocker switch, located just
above the AC cable receptacle. To reset to Factory settings, press
and hold Master Volume knob and Tone button at power up.
2. Bluetooth® Pairing Button - Using Bluetooth, your AMPLIFi amp
will communicate wirelessly with your iOS device. Before you run
the AMPLIFi Remote app, set up Bluetooth as follows:
To pair your amp with your iOS device:
• Enter Pairing Mode by pressing the Bluetooth button - it will ash.
• Your amp's unique name will appear on your iOS device.
• Select your amp's unique name - this pairs it up with your device!
3. Guitar Input - Plug in your 1/4 inch guitar cable here. Run the
AMPLIFi amp in standalone mode or with the AMPLIFi Remote
app.
4. Tone Controls - When using AMPLIFi Remote with your iOS device,
all Tone adjustments can be made using the app Editor. You can also
tweak your guitar sound manually with these onboard Tone controls:
DRIVE: Adjusts the current Amp Model's Drive level.
BASS, MID, TREBLE: Adjusts the Bass, Mid and Treble levels for
the current Amp Model's tone stack.
FX: Adjusts the FX parameter saved with the preset and selected in
the AMPLIFi Remote application.
REVERB: Adjusts the Reverb level for the current Guitar Preset.
5. Master Volume Knob - This big knob controls the overall output
level of your AMPLIFi amp. It also has a Secondary Function of
adjusting your guitar level relative to the overall audio mix. This can
be useful when you're jamming to a track and your guitar level is too
soft or too loud.
To achieve a good balance, simply press the Master Volume knob to
activate its Secondary Function, then set your guitar level as desired.
After 5 seconds, the knob reverts to Master Volume control.
Master Volume LED RIng
Master Volume LED Ring - The ring of LEDs surrounding the Master
Volume knob light up in various ways, depending on the current
parameter being adjusted, as follows:
• Master Volume: LEDs are lit red to indicate Master Volume level.
• Guitar Level: When the Secondary Function is activated via knob
press, all LEDs are lit white; as your guitar level is adjusted, LEDs
are lit red.
• Tone Controls: When an individual Tone Control is adjusted, the
saved level is indicated in red; all other LEDs are lit white to display
the current level as you turn the knob.
6. Preset Select Button - There are 4 onboard Presets stored in your
AMPLIFi amp's internal memory: Presets A, B, C and D. These can
be overwritten at any time, replaced by up to 4 Favorite Presets.
A
B
C
D
Preset Select and Tap Tempo Buttons
To Recall A Preset: Press the Preset Select Button repeatedly to
cycle through the A, B, C and D Presets. The white LEDs will indicate
your current selection.