® DT25 Guitar Amplifier Pilot’s Guide Manuel de pilotage Pilotenhandbuch Pilotenhandboek Manual del Piloto 取扱説明書 40-00-0311 Pilot’s Handbook available @ www.line6.
Important Safety Instructions C AU T IO N R ISK O F E LE C TR IC SH O C K DO NOT O PE N WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THE APPLIANCE TO RAIN OR MOISTURE. CAUTION: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of FCC Rules.
You should read these Important Safety Instructions. Keep these instructions in a safe place • • • • • • • • • • • • • • • • • • • • • Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
Front Panel Controls & Connections 1. Guitar In – Plug your guitar in here. 2. Power Switch – Connect the included power cable to your rear panel. For optimum tube life always power your amp on with your amp set to STBY. 3. Standby Switch – Allow the amp to warm up for one minute before setting STBY to ON. This extends the life and performance of your vacuum tubes.
counter-clockwise. VOLUME sets the output level for its channel only. 6. Channel Select Switch – DT25 features two independent channels, A & B. When set to A, use the (5A) controls. For B use the (5B) controls. You can assign unique combinations of Voicing/ Feedback Topology, Amplifier Operating Class and Pentode/ Triode settings for each channel. This provides much more than the traditional clean/dirty channel configuration.
14. Footswitch – Connect a Tip-Ring-Sleeve (TRS) latching, two-button footswitch for easy access to switching Reverb On and Off (Global) and switching between Channels A & B.Alternately, connecting a Tip-Sleeve (TS) latching, single-button footswitch provides easy access to switching between Channels A & B. 15. Low Volume Mode - If you need to tame your DT25 power section, set this switch to ON to reduce your the output volume of your DT25. Now you can set your Master Volume for whisper quiet operation. 16.
MIDI Implementation Continous Controller (MIDI CC #) Value Function 19 0-63 = Channel A, 64-127 = Channel B Channel A/B Toggle 77 0 = Voicing I, 1 = Voicing II, 2 = Voicing III, 3 = Voicing IV Channel A Voicing (I, II, III, IV) 73 0-63 = Class A, 64-127 = Class AB Channel A Operation Class Configuration (Class A / Class AB) 75 0-63 = Triode, 64-127 = Pentode Channel A Power Tube Configuration (Pentode/Triode) 36 0-63 = Reverb Off, 64-127 = Reverb On Channel A Reverb On/Off 114 0 = Voicing
