User Manual

Front Panel Controls & ConneCtions
1. Guitar In – Plug your guitar in here.
2. Power Switch – Connect the included power cable to your rear panel.
For optimum tube life always power your amp on with your amp set to
STBY.
3. Standby Switch – Allowtheamptowarmupforoneminutebefore
setting STBY to ON. This extends the life and performance of your
vacuum tubes. It is not necessary to set the amp to STBY before
setting the Power Switch to its OFF position, but it can be a good
habit,ifonlytoensureyou’vegotitsetproperlynexttimeyoupower
up the amp.
4. Master Volume – Setstheoverallvolumeoftheamplierwithout
having to change your individual channel settings.
5. Channel A & B Controls – DRIVE controls how much “dirt” or
“distortion” you get in your sound. BASS, MID, TREBLE and
PRESENCE controls will interact differently depending on which
VOICING you have selected. REVERBadjuststhechannel’sreverb
level, allowing you to switch between channels with different amounts
of reverb.If you don’twant any reverb, simply turn this knob fully