User Manual
Table Of Contents
- HX Stomp XL 3.0 Owner's Manual
- Welcome to HX Stomp XL
- Quick Start
- Play View
- Edit View
- Selecting Blocks/Adjusting Parameters
- Bypassing a Block
- Bypassing HX Stomp XL Completely
- Choosing a Block’s Model
- Moving Blocks
- Copying/Pasting a Block
- Clearing a Block
- Clearing All Blocks
- Adding a Block to Favorites
- Saving a Model’s Default Settings
- Saving/Naming a Preset
- Creating /Restoring Full Device Backups
- Serial vs. Parallel Routing
- Setting Path B’s Output
- TAP Tempo
- The Tuner
- Dynamic DSP
- Block Order and Stereo Imaging
- The Blocks
- Snapshots
- Bypass Assign
- Controller Assign
- Command Center
- Global EQ
- Global Settings
- USB Audio
- MIDI
- Additional Resources
15
2. Press the footswitch displaying the block you want to edit.
Theblock’srstpageofparametersappearsatFS1~FS3,withtheireditablevalues
above. In the following example, the Multi Pass Delay block was selected, and its
rstpageofthreeparametersisdisplayed.
EDIT / EXIT
TUNER
TAP
MODE
B
D
A
C
VALUE-
PAGE
HOLD: PAGE
Pattern
Feedbk
Time
VALUE +
37% 41200s
Multi Pass
If the block has more than one page of parameters, press and release FS4 (PAGE )
or press and hold FS4 ( PAGE) until you nd the desired parameter.
3. Press the footswitch displaying the parameter you want to adjust.
In the above illustration, the delay’s Time parameter is selected. Press and hold a
Time or Speed switch to toggle between setting the value in ms or Hz and note
divisions (1/4-note, dotted 1/8-note, etc.).
4. Press FS5 (VALUE -) or FS6 (VALUE +) to incrementally adjust the
parameter’s value, or hold FS5 or FS6 for large adjustments.
You can also use a connected expression pedal to make adjustments to the selected
parameter.
5. When nished, press the MODE switch from the Block Select
screen to exit Pedal Edit mode.
If you want to save any changes made to the preset when exiting Pedal Edit mode,
press and hold MODE for two seconds.
Toeditadierentblock,pressandholdtheMODEswitchtoenterPedalEditmode
again.