User Manual
Table Of Contents
- HX Stomp XL 3.0 Owner's Manual
- Welcome to HX Stomp XL
- Quick Start
- Play View
- Edit View
- Selecting Blocks/Adjusting Parameters
- Bypassing a Block
- Bypassing HX Stomp XL Completely
- Choosing a Block’s Model
- Moving Blocks
- Copying/Pasting a Block
- Clearing a Block
- Clearing All Blocks
- Adding a Block to Favorites
- Saving a Model’s Default Settings
- Saving/Naming a Preset
- Creating /Restoring Full Device Backups
- Serial vs. Parallel Routing
- Setting Path B’s Output
- TAP Tempo
- The Tuner
- Dynamic DSP
- Block Order and Stereo Imaging
- The Blocks
- Snapshots
- Bypass Assign
- Controller Assign
- Command Center
- Global EQ
- Global Settings
- USB Audio
- MIDI
- Additional Resources
44
Copying/Pasting a Snapshot
Instead of creating a new snapshot from scratch, you may want to copy an existing one
to another snapshot location and tweak just a few things.
1. From Snapshot mode, while touch-holding the footswitch for
the snapshot you want to copy, briey touch and release the
footswitch for the snapshot you want to overwrite.
A dialog panel appears:
OKCancel
Copy Snap 1 to 2?
2. Press Knob 3 (OK).
NOTE: The “touch” behavior for footswitches can be disabled using the
Stomp Select option in”Global Settings > Footswitches”
Swapping Snapshots
1. From Snapshot mode, simultaneously touch-hold the two
footswitches for the snapshots you wish to swap until the
following dialog appears:
OKCancel
Swap Snaps 1 and 2?
2. Press Knob 3 (OK).
Saving Snapshots
Press and ACTION together twice to save the preset.
Saving a preset stores all of its four snapshots automatically.
NOTE: Selecting a preset recalls the snapshot that was active when the preset
was saved.
Determining Snapshot Edit Behavior
Say you’re on Snapshot 2 (verse), and you change a few things—switch a delay block
on,switchamodblocko,tweakadistortion’sDriveparameter,etc.Ifyouswitchto
Snapshot 3 (chorus) and then back to Snapshot 2 for the second verse, should HX
Stomp XL recall those changes or return Snapshot 2 to its state when the preset was
last saved? There’s no right answer, therefore, HX Stomp XL lets you choose.
1. Press PAGE and PAGE together to open the Menu.
2. Press PAGE and then press Knob 2 (Global Settings).
3. Turn the Upper Knob to select the Preferences submenu.
4. Turn the Snapshot Edits knob to set snapshot edit behavior:
• Recall—Any snapshot edits are recalled when jumping from snapshot to
snapshot and appear as you last left them (the default).
• Discard—Any snapshot edits are discarded when jumping from snapshot to
snapshot and appear as the preset was last saved. If you want to save changes
made to the current snapshot while Snapshot Edits is set to “Discard,” press
the and ACTION buttons together twice to save before selecting another
snapshot.
The camera icon on the Play screen shows you the Snapshot Edits setting at a glance—
Whensetto“Recall,”thecameraisgray;whensetto“Discard,”thecameraisred.
1
1
RECALL DISCARD
NOTE:Don’tforgettosavebeforechangingtoadierentpresettostoreallyour
snapshot settings!