User Manual

53
HX Loop (Looper) - Footswitch
Page Knob Parameter Description
1
2 Behavior
Sets the behavior for the footswitch. This allows
you to send up to two dierent Looper commands,
independently per each Press and Release or each
Press and Hold of the footswitch. (Note that the
assigned, Stomp mode footswitch’s label and LED
will only indicate the command assigned to the Press
function.)
3 Press
Sets the Looper command to be sent on the Press
action of the footswitch.
2 1
Release/
Hold
Sets the Looper command to be sent on the Release
(or Hold, depending on your page 1, knob 2 selection)
of the footswitch.
Note that the assigned, Stomp mode footswitch’s label and LED will only indicate
the command assigned to the Press function.
Copying and Pasting a Command
1. Select the location containing the command you wish to copy
and press ACTION.
2. Press Knob 1 (Copy Command).
3. Select the location to which you want to paste the command—
even in a dierent preset—and press ACTION.
4. Press Knob 3 (Paste Command).
Copying and Pasting All Commands
Setting up the same or similar set of commands across multiple presets can quickly
become tiresome. Fortunately, HX Stomp XL lets you quickly copy and paste all
commands to another preset.
1. From the Command Center page, press ACTION.
2. Press Knob 2 (Copy All Commands).
3. Select the preset to which you want to paste the commands
and press ACTION.
4. Press Knob 3 (Paste All Commands).
Clearing a Command
1. Select the location containing the command you want to clear
and press ACTION.
2. Press Page 2, Knob 1 (Clear Command).
Clearing All Commands
1. From the Command Center page, press ACTION.
2. Press Page 2, Knob 2 (Clear All Commands).
The following dialog appears:
OKCancel
Clear all Commands?
3. Press Knob 3 (OK).