User Manual

Setup Examples
10•16
For the Channel 6 vocal mic, we’ll load the Female Lead vocal preset. To do this, tap
the Mic stage icon to select it (it will be highlighted green), then scroll the Stage Icon
Gallery until you see the Female Lead icon. Tap it and the Female Lead preset will
load into Channel 6, replacing the generic Mic (6) preset and its stage icon.
Regarding the FX processor: it will be fed by Monitor Outs D, so when plugging into
the M20d I/O Panel, it may initially be represented by a floor monitor stage icon. We’ll
replace it with a Line icon as follows:
• Tap the monitor icon to select it (it will be highlighted green).
• Scroll the Stage Icon Gallery until you see the Line icon (mono).
• Tap the Line icon (mono) and it will replace the monitor icon on the stage.
A note about the FX processor: any channels that use it should be adjusted to send
their audio to the Monitor D output in Monitor Mode. This is done using the same
procedure as used for sending channel audio to stage monitors A or B.
For your final setup step, rearrange all the stage icons to resemble the layout illustrated on
Page 11. And be sure to review Pages 17 & 18 for more setup tips.