User Manual

Tweak Mode
3•4
C. Load/Save Preset
Tap the Folder Icon to the right of the Channel Name to
open the Load/Save Presets window.
Tapping Load Preset will open the Load Preset browser,
with options to load a Preset from the Preset Library,
Delete or Rename the Preset, and other functions
described in detail on Page 2•13 in Chapter 2: Setup
Mode of this Guide.
Tap Save Preset to save the current preset to the Preset
Library, replacing the Factory Preset on which it is based.
Tap Save Preset As... to name and save the current preset
to the Preset Library.
D. Trim Tracking, FBS Enable, Mute & Solo Buttons
These 4 buttons enable Trim Tracking, Feedback
Suppression, Mute On/Off, and Solo/On Off. See more
details on Trim Tracking and Feedback Suppression in
the Deep Tweak section of this chapter.
E. Pan & Level Controls
Set Channel Pan position with this control, which is
matched to hardware encoder #1, color-coded yellow.
Set Channel Level using encoder #7, color-coded green.
F. Quick Capture Buttons
These buttons are full time Quick Capture transport controls. Tap the Record
button at any time to capture 20 seconds of live audio to the M20d’s internal
memory. Tap the Play button to play it back. Playback will loop continuously
until you tap Stop. If your press Record again, the previously captured audio will
be replaced by the new recording.
Quick Tweak XY Processors
In addition to Punch, illustrated on Page 3•2, the other Quick Tweak processors
available via the left row tabs are illustrated on the following pages, beginning with Tone.
The available processors depend on which Channel Preset/DSP Type is loaded.