User Manual

Managing L6 LINK Devices
8•2
Auto Assign L6 Speakers: On
When Auto Assign L6 Link Speakers is set to ON, the M20d assigns L6 LINK connected
speakers to its outputs based on the type of speakers, the number of speakers connected,
and their position.
For Example, if only one L3t vertically oriented speaker is connected, the M20d will assign
it to L+R (Main Left + Main Right). If it is horizontally oriented, the M20d will assign it
to Aux A. If only one L3s (Sub) is connected, the M20d will assign it to L+R (Main Left
+ Main Right).
When a vertically oriented speaker’s position is inverted, vertically tilted, vertical or
unknown, it is assigned to M20d outputs according to Table 1 (see Page 3).
When a vertically oriented speaker’s position is 0° horizontal, 30° horizontal or 60°
horizontal, it is assigned to M20d outputs according to Table 2 (see Page 4). *Speaker tilt
angle refers to its flat orientation (0°) or leaning back on its handle or tilt stands.
StageSource L3s speakers (Subs) are assigned to M20d outputs according to Table 1.
Note: If a speaker’s orientation changes while Auto Assign L6 LINK Speakers is set to
ON, its orientation will not change within this view. In order to indicate any orientation
changes that may have occurred while Auto Assign L6 LINK Speakers is set to ON,
you must toggle the Auto Assign button OFF, then ON again. This is useful because it
allows you to change your intended orientations without changing your assignments.