User Manual

Managing L6 LINK Devices

8•8

Detach

The Detach button removes the M20d output assignment from the L6 LINK connected

speaker. This provides a means of effectively muting the L6 LINK connected speaker,

which may be useful during setup for speaker isolation or troubleshooting.

Sorting

At times it may be useful to sort your L6 LINK connected speakers by different attributes,

especially when using a large number of speakers. Tapping the Sort buttons will sort L6

LINK connected speakers in this view as follows:

Index

Sort by the speaker list item’s index number (see Speaker Description above)

Output Buss

Sort by the speaker list item’s assigned output (see Output Assignment above)

L3 Type

Sort by the speaker list item’s model type (see Speaker Description above)

Note: Changing Sort setting does not alter speaker’s properties or output assignment.

Set Crossover Frequency

Set Crossover Frequency sets the crossover frequency for all StageSource speakers

assigned to Mains L, R, or L+R within the L6 LINK conﬁguration. The default is 120 Hz.

There are two ways to set the L6 LINK crossover frequency. One is via the UI interface

shown above; the other is to use the L3s speaker’s crossover button. The last change wins.

Note: The selected crossover frequency will affect all speakers assigned to Mains L, Mains

R, or Mains L+R. If no L3s speakers are connected, the selection is disabled, and the M20d

will turn off the crossover frequency for all connected L3t speakers.