User Manual

Setup Examples
10•12
M20d Setup (Electronic - Phase1)
Power up the M20d in Setup Mode then connect the following to the M20d hardware
I/O Panel:
• Laptop 1/4 inch audio interface outputs 1-4 into M20d Combi Inputs 1-4 (4 ‘Line’
stage icons will appear on the stage, along with 4 Line controller strips).
• Floor monitors A and B into Monitor Outs A and B (2 Monitor stage icons will
appear on the stage, along with controller strips for Monitors A and B).
• If used, your powered PA monitors plug into Main Outs Left and Right.
Before we go any further, let’s create a new M20d Setup by tapping the Setups button
in the Main Toolbar, tapping Save, then naming the Setup “Electronic Setup”. All
settings from this point forward will be saved as “Electronic Setup” for future recall.
Now let’s create a stereo channel for the laptop Inputs 1 and 2, as follows:
• Select the Line 1 stage icon - a Make stereo pair button will appear in the upper
right of the display, as illustrated below.
• Tap the Make stereo pair button - will appear in the upper right of the display, as
illustrated below. - the Line 1 and Line 2 stage icons will be replaced by a stereo
Line icon (1/2)