Owner's Manual

ManualsBrandsLinear ManualsMisc ElectronicsLinear 272i

Features,Programming, and Wiring Guide

The DoorwGard Wiegand Series Keypads allow your Wiegand protocol based

access control installations to be tailored to your individual needs. DoorwGard

Wiegand Series Keypads provide user configurable communications which conform

to a variety of standard Wiegand formats.

XtremePad

l l For extremely

hostile environments

l l Waterproof (submersible)

ll Stainless-steel

construction

l l Corrosion-proof

l l Solid State Keys

MultiPad

l l Contemporary design

l l Illuminated keys*

ll Indoor\outdoor

construction

l l Weatherproof

*w/12vdc input

Indoor

l l Brushed-stainless

steel plate

l l Tactile keys

ll Single-gang flush-

mount

Weatherproof

l l Machined-aluminum

housing

l l High-durability metal

keys with Braille

numbers

ll Fits over standard

single-gang

electrical box

INTERNATIONAL ELECTRONICS, INC.

427TURNPIKE STREET, CANTON,MA 02021 U.S.A.

800-343-9502, 781-821-5566

781-821-4443 (FAX)

FAX INFORMATION CENTER 781-821-0734 (FROM YOUR FAX MACHINE)

Wiegand

6057130 REV 1.1

272mp 272xt

272i 272wp

272 Series

Summary of content (4 pages)

PAGE 1
Wiegand 272 Series Features,Programming, and Wiring Guide 272mp 272xt 272i MultiPad XtremePad Indoor TM l Contemporary design l Illuminated keys* l l Indoor\outdoor construction TM l l l Weatherproof For extremely hostile environments Waterproof (submersible) Stainless-steel construction l Corrosion-proof l Solid State Keys l l l Brushed-stainless steel plate Tactile keys 272wp Weatherproof l l Single-gang flushmount l Machined-aluminum housing High-durability metal keys with
PAGE 2
1 2 TESTING THE KEYPAD PROGRAMMING 1. Connect the positive (=) lead of your 5 or 12VDC power supply from the control panel to the terminal (TS1) =V input. 1. Enter programming mode 1 Press 99 # (master code ) * or press sw1 switch 2. Connect the negative (-) lead of your 5 or 12VDC power supply from the control panel to the terminal strip (TS1) -V input. 3. Turn on power supply. 4. Enter Self Test Mode: Press 7890#123456*. The leds will light sequentially, and the sounder will beep 3 times.
PAGE 3
PROGRAMMING OPTIONS CHART If the pre-programmed default values must be changed or additional functions are desired, the following options may be programmed. 1. Enter programming mode 2. Auto entry on (no * required) 3. Auto entry off ( * required) 4. Sounder feedback on keypress 5. Sounder feedback on keypress off 6.
PAGE 4
Current Draw @ 5VDC - 13.2ma MAX @12VDC- 38.2ma MAX 272mp SW1 272MP- No backlighting if Weigand panel power outputs 5v to Weigand reader. A separate (12vdc) supply will be needed with a common ground between keypad and Weigand panel. BASIC WIEGAND CONTROL PANEL + DA0 DA1 LED P1- On = Backlit enabled (12vdc only) Off = Backlit disabled P1 + - 272xt DA0 DA1 LD1 LD2 To Control Panel red black P1 white\yellow black\white Current Draw @ 5VDC - 4.6ma MAX @12VDC- 11.