Owner's Manual

INSTR,INST,AE-HOOD Linear P/N: 215659 C Material: 20 Lb. Mead Bond Size: 8.500" x 11.000" Ink: Black Scale: 1-1
AE-HOOD
Conversion Kit
Installation Instructions
1. OPEN CABINET 2. REMOVE BOLTS 3. POSITION HOOD
4. INSTALL BOLTS 5. CLOSE PANEL/TEST LINEAR LIMITED WARRANTY
This Linear product is warranted against defects in material and
workmanship for twelve (12) months. The Warranty Expiration
Date is labeled on the product.
This warranty extends only to
wholesale customers
who buy direct from Linear or through
Linear’s normal distribution channels.
Linear does not warrant
this product to consumers.
Consumers should inquire from
their selling dealer as to the nature of the dealer’s warranty, if
any.
There are no obligations or liabilities on the part of
Linear Corporation for consequential damages arising out
of or in connection with use or performance of this product
or other indirect damages with respect to loss of property,
revenue, or profit, or cost of removal, installation, or
reinstallation.
All implied warranties, including implied
warranties for merchantability and implied warranties for fitness,
are valid only until Warranty Expiration Date as labeled on the
product.
This Linear Corporation Warranty is in lieu of all
other warranties express or implied.
All products returned for warranty service require a Return
Product Authroization Number (RPA#). Contact Linear Technical
Services at 1-800-421-1587 for an RPA# and other important
details.
IMPORTANT !!!
Linear radio controls provide a reliable communications link and
fill an important need in portable wireless signaling. However,
there are some limitations which must be observed.
✶
For U.S. installations only: The radios are required to
comply with FCC Rules and Regulations as Part 15 devices.
As such, they have limited transmitter power and therefore
limited range.
✶
A receiver cannot respond to more than one transmitted
signal at a time and may be blocked by radio signals that
occur on or near their operating frequencies, regardless of
code settings.
✶
Changes or modifications to the device may void FCC
compliance.
✶
Infrequently used radio links should be tested regularly to
protect against undetected interference or fault.
✶
A general knowledge of radio and its vagaries should be
gained prior to acting as a wholesale distributor or dealer,
and these facts should be communicated to the ultimate
users.
Copyright © 2000 Linear Corporation 215659 C
[phone] • FAX [phone]
USA & Canada [phone] & [phone]
Toll Free FAX [phone]
www.linearcorp.com
UNLOCK CABINET
AND LOWER FRONT
PANEL
REPLACE
BOLT AND
NUT
ALIGN HOLES IN HOOD
WITH FRONT PANEL
USE NEW 1/4-20 X 3/4 SCREW FOR SIDE SHOWN.
PLACE WASHER AND TETHER ON SCREW AND
SECURE WITH NUT. USE EXISTING HARDWARE
FOR OTHER SIDE NOT SHOWN.
CLOSE CABINET
AND LOCK
NOTE: THOROUGHLY TEST
PANEL ACCORDING TO
INSTALLATION MANUAL TO
ENSURE UNIT IS WORKING
PROPERLY
LOOSEN AND REMOVE TWO TOP
NUTS AND BOLTS ON BOTH SIDES
OF CABINET
SLIDE HOOD OVER
FRONT PANEL