Owner's Manual

2
INSTALLATION
Before installing the keypad, the unit must be partially disassembled
to access the mounting plate.
Opening the Keypad
The keypad assembly is secured with two screws that are hidden
behind the keypad’s nameplate. Refer to Figure 3 for disassembly
details.
❑ Use a small flat blade screwdriver to pry off the keypad’s
nameplate.
❑ Use a philips head screwdriver to remove the two screws.
❑ Separate the mounting plate from the keypad assembly.
Install the Electrical Box and Mounting Plate
The keypad is designed to fit into a standard single-gang electrical
box. Select a location near the controlled door and choose a
convenient height for the keypad. Be sure there is good wiring
accessibility for the unit’s power and the output to the door strike
or access device.
❑ Install the electrical box in the wall.
❑ Screw the mounting plate onto the electrical box (see
Figure 4).
Final Keypad Installation
After wiring the keypad (see next page), complete the installation
by securing the keypad to the mounting plate.
❑ If a lower beeper sound level is required, before installing
the keypad, remove Jumper at P4 (place the jumper block
on one pin to save the jumper).
❑ Hook the keypad assembly onto the mounting plate tab (see
Figure 5).
❑ Secure with two philips screws.
❑ Snap nameplate into position over screws.
HOOK THE KEYPAD ASSEMBLY
ONTO THE MOUNTING PLAT
E
1
2
3
INSTALL THE
TWO SCREWS
SNAP THE NAMEPLAT
E
INTO PLAC
E
Figure 5. Connecting the Keypad to the Mounting Plate
221025 C IMAGE 4 221025 C IMAGE 5
1
PRY UP ON THE
NAMEPLAT
E
HERE
3
SEPARATE THE
MOUNTING PLAT
E
FROM THE KEYPAD
MOUNTING
PLAT
E
REMOVE THE
TWO SCREWS
2
Figure 3. Opening the Keypad
INSTALL A SINGLE-GANG
ELECTRICAL BOX AT TH
E
PROPER LOCATION
FOR THE KEYPAD
ATTACH THE MOUNTING
PLATE TO TH
E
ELECTRICAL BOX
MAKE SURE THE
TAB IS UP
MOUNTING
PLAT
E
Figure 4. Installing the Mounting Plate