Quick Start Manual

AM-RPR
Remote
Proximity
Receiver
Installation
Instructions
INTRODUCTION
The AM-RPR remote proximity receiver is designed for use with Linear’s
AE1000Plus, AE2000Plus, and AM3Plus access control systems. The
AM-RPR functions as a remote PBUS device that supplies localized radio
reception for the controller.
In a typical installation, the AM-RPR would be mounted in a plastic
single-gang electrical box next to the controlled opening. When the user
requires access, their transmitter must be activated within three inches
of the AM-RPR faceplate. The ultra-short range of the AM-RPR allows
placement of a unit by each controlled opening without the possibility of the
transmitter being detected by the wrong receiver.
A two-color indicator on the AM-RPR faceplate displays the receiver’s
status. The indicator lights red when the receiver is getting DC power from
the controller and turns green when access is granted to a transmitter.
The AM-RPR remote proximity receiver connects to the controller through a
six-wire cable. A small ferrite ‘doughnut’ is supplied for the wiring to reduce
radio reception in the wires. A rotary switch in the AM-RPR selects the
PBUS device address for the receiver. Each remote device connected to the
controller must be set to a different device address. Power is supplied to the
receiver from the controller.
A special test mode can be selected to test the radio reception. When the
unit is powered and the device address selector is set to 7, activating a
transmitter in range of the receiver causes the test beeper to sound and the
indicator to blink.
1. TYPICAL INSTALLATION
2. LOCATE COMPONENTS 3. INSTALL SWITCH BOX & ROUTE WIRING 4. CONNECT AM-RPR TO CONTROLLER
USA & Canada [phone] & [phone]
[phone] - Toll Free FAX [phone]
www.linearcorp.com
EACH AM-RPR EQUALS 4 LOAD UNITS
CABLE LENGTH FORMULA FOR EACH AM-RPR USED IN SYSTEM
CABLE RUN CABLE TYPE FORMULA
300 FEET MAXIMUM
BELDEN 9931 (24 AWG)
WEICO 9405 (20 AWG)
FEET x LOAD UNITS < 3,000 MAXIMUM
FEET x LOAD UNITS < 10,000 MAXIMUM
500 FEET MAXIMUM
CABLE TO CONTROLLER
(SEE FORMULA
)
AM-RPR
ELECTRIC STRIKE
ON DOOR
(IN JAMB)
DEVICE
ADDRESS
SELECTOR
TEST
BEEPER
(OTHER SIDE)
POWER & DATA
TERMINALS
(CONNECTS TO CONTROLLER)
INSTALL
ELECTRICAL
BOX IN WALL
ROUTE WIRING
FROM CONTROLLER TO
ELECTRICAL BOX
STRIP BACK WIRE'S OUTER INSULATION 8 INCHES
WRAP WIRES 3 OR 4 TIMES AROUND THE
FERITE "DOUGHNUT" (THIS KEEPS THE
TRANSMITTERS FROM BEING RECEIVED
ALONG THE CABLE)
AM-RPR
AM-RPR
TERMINALS
PCLK
DVAL
DAT0
DAT1
GND
PWR
GND
DAT1
DAT0
DVAL
PCLK
PWR
ACCESS CONTROL
SYSTEM PBUS
TERMINALS
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,AM-RPR PROXIMITY RECEIVER- LINEAR P/N: 211773 C - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 11.000” X 8.500” - SCALE: 1-1 - SIDE 1 OF 2