Operations and Installation Manual I M3300CD AM / FM Receiver with CD Player ® A Registered Trademark of Magnadyne Corporation
Introduction Your new M3300CD in-dash entertainment system has been designed to give you many years of listening pleasure. Take a moment to read through this manual and become familiar with the operations and features of this outstanding product. It is advisable to keep this manual in your vehicle so it is readily available for reference.
Location and Function of Controls at a Glance (continued) 6. Mode Button (MODE): Press the MODE button to change the operating mode as follows: RADIO > CD* > USB* > SD* > AUX > RADIO. *Available only when there is media inserted into Disc slot, SD card slot or USB slot. 7. Track Up Button ( ��l ): Adjusts the radio frequency, changes tracks and sets the clock. 8. SD Card Slot: Insert a SD card with the notch in the card facing up, “SD” will appear in the display. 9.
Radio Operation Select a Band Press the MODE button until either F1, F2, F3, A1 or A2 appear in the display. Next press the BAND button to select the desired band: F1, F2, F3, A1 or A2. Tuning Automatic Search Tuning: Press the ��l or l�� button to move to the next or previous station automatically. Manual Tuning: Press and hold the ��l or l�� button until “MANUAL” appears in the display. Then press and release the ��l or l�� button until desired frequency is selected.
Radio Operation (continued) TA Seek / TA Alarm In TA Alarm mode, the alarm is set off. 1. Press and hold the VOL knob for a few seconds then release. 2. Continue to press the knob until “TA ALARM” appears in the display. 3. Rotate the VOL knob until “TA SEEK” appears in the display. In TA SEEK mode, the unit will seek for Traffic Announcement program. PTY (Program Type) 1. Press and hold DIS button to activate the PTY function. 2. Rotate the VOL knob to select the PTY type. 3.
General Operations Turning the Unit On Press any button to turn on the unit. Press and hold PWR button to switch the unit off. Display Button The display feature allows you to see the clock and information for the current operating mode. Each press will change the information displayed. Mode: Press the MODE button to change the operating mode as follows: RADIO > CD* > USB* > SD* > AUX > TUNER. *Available only when there is media inserted into Disc slot, SD card slot or USB slot.
CD, USB and SD Card Operation (continued) File / Folder Search Function When playing MP3/WMA files from a CD, USB Memory or SD/MMC Card, press AS/PS button to enter search mode. Sequence of search modes: File Number Search -> File Name Search -> Folder Search -> Exit search mode. Note: Commercial audio-CD discs only support file number search. File Number Search 1. Press AS/PS button to enter file number search. * * 2.
Installation Procedures Step 1: The radio chassis is designed to be “Sleeve Mounted” through a opening in the dashboard panel. The required opening size is 182mm (7-3/16”) x 52mm (2-1/16”). Cut or enlarged an opening in the dashboard to accommodate the mounting sleeve. Step 2: If you are replacing an existing factory installed radio, an adapter harness might be available for your vehicle to eliminate the need for cutting your factory wiring.
Wiring Diagram 15 A Fuse Antenna Socket Sub Woofer Red Wire Ignition Switch (+12v in ) Yellow Wire Battery (+12v in) Red Right Channel Black Wire Ground (B-) Blue Wire Power Antenna (Switched 12v out) Audio Line Output White Left Channel Left Front Speaker White Wire Gray Wire White Wire with Black Stripe Gray Wire with Black Stripe Left Rear Speaker Green Wire Violet Wire Green Wire with Black Stripe Violet Wire with Black Stripe Right Front Speaker Right Rear Speaker 9
Audio Line Out Connection Cable Not Supplied M3300CD Optional Speaker Amplifier Red (Right) White (Left) Sub Woofer Connection Cable Not Supplied M3300CD Optional Sub Woofer Amplifier Blue (Sub Woofer) Final Installation - Method A Mounting Sleeve Sheet Metal Screw Nut Push Out Mounting Sleeve Tabs Washer Metal Strap Dashboard Removal Keys Installing the Unit 1: Insert the sleeve into the dashboard opening and bend the mounting tabs outward to secure it.
Final Installation - Method B 2 3 1 3 5 2 Installing the Unit 1: Screw holes on the side of the unit. 2: Screws. Use wither truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 4 Note: The mounting sleeve, outer trim ring, and the mounting strap are not used for this method of installation. 3: Vehicle’s factory mounting bracket. 4: Dashboard or console. 5: Hook (Remove this part). Specifications CD Player Signal/Noise Ratio...............
Warranty ONE (1) YEAR LIMITED WARRANTY Magnadyne Corporation or its authorized agents will within one year from the date of sale to you, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.