Carbon Monoxide Alarm

ManualsBrandsLinear ManualsSmoke AlarmDXS-80

DXS-80

The DXS-80 is a UL listed

†

, single

station, carbon monoxide alarm with

a built-in supervised transmitter. It is

compatible with Linear’s wireless

DXS Format Security Systems, Personal

Emergency Reporting Systems (PERS),

and other stand-alone receivers. The

DXS-80 provides a warning to alert

against both the acute and chronic

effects of carbon monoxide (CO)

poisoning.

When carbon monoxide is detected,

the alarm sounds a loud local alarm.

The built-in transmitter sends a digitally

coded wireless signal to its companion

receiver every 20 seconds until the air

has cleared and the detector is restored.

The local alarm can be silenced once by pressing the test/

reset button. The transmitter will continue to send an alarm

signal every 20 seconds. After 7 minutes, the alarm will sound

again if there is still an unsafe carbon monoxide concentration

level. The reset function can be used only once for each alarm

occurrence.

No field coding is required because the DXS-80 is factory set to

a unique code; one of over a million possible codes.

The DXS-80 is powered by one 3-volt

lithium battery. The battery is supplied

and can power the unit for up to the

six year life of the detector. If the

battery voltage drops below a preset

level the alarm will sound a low

battery chirp every 45 seconds and a

low battery signal will be sent to the

receiver.

At about 6 years, the carbon monoxide

detector element will reach the end of

its serviceable life. The self-supervising

detector will signal a permanent

trouble condition, indicating time for

replacement.

SPECIFICATIONS

REGULATORY LISTINGS: UL2034

DETECTION METHODS: Electrochemical

TIME TO ALARM PER UL 2034:

Carbon Monoxide

Concentration Level

Minimum Time

to Alarm

Maximum Time

to Alarm

50 ppm +/-5 ppm 30 days Indefinite

70 ppm +/-5 ppm 60 min 240 min

150 ppm +/-5 ppm 10 min 50 min

400 ppm +/-5 ppm 4 min 15 min

AUDIBLE OUTPUT: 85 dBA/10'

OPERATING TEMP. RANGE: 32º-100º F

POWER: 3-Volt battery (Lithium Type 123A)

(UL tested for greater than 1 year service life)

CURRENT: 7 mA alarm average, 15 µA standby

FREQUENCY: 315 MHz

NUMBER OF CODES: One of 1,048,576 possible codes

DIMENSIONS: 5.3" diameter, 2.0"h

COMPATIBLE RECEIVERS

†

: PERS-3600 PERS-2400A

DXSR-1504 DXSR-1508

DVS-1200 DXR-702

DUAL-824 DVS-2400

Model DXS-80

(SST00116)

Carbon Monoxide Alarm

Wireless Carbon Monoxide

Alarm

Model DXR-702

(SNR00149)

2-Channel Receiver

Also available as a kit:

DX-COKIT

(SSA00020)

Kit contains one DXR-702 receiver

with a DXS-80 already learned into

the receiver

NOTE: The DX-COKIT is not for use

in UL Listed applications

† The DXS-80 is currently UL Listed for use with the Linear PERS Consoles only. It has not

been tested by UL with other compatible Linear receivers.

Summary of content (2 pages)

PAGE 1
DXS-80 Wireless Carbon Monoxide Alarm The DXS-80 is a UL listed†, single station, carbon monoxide alarm with a built-in supervised transmitter. It is compatible with Linear’s wireless DXS Format Security Systems, Personal Emergency Reporting Systems (PERS),, and other stand-alone receivers. The DXS-80 provides a warning to alert against both the acute and chronic effects of carbon monoxide (CO) poisoning. The DXS-80 is powered by one 3-volt lithium battery.
PAGE 2
DX-COKIT DXS-80 DXR-702 The DX-COKIT is an excellent way to add CO protection to new or existing security alarm panels NOTE: The DX-COKIT is not for use in UL Listed applications Security Alarm Panel Security Alarm Panel Requirement: Available input(s) which can accept a dry N.C. or N.O. contact DX-COKIT • Includes one DXS-80 CO Detector and one Linear DXR-702 Receiver, with the DXS-80 already learned into the receiver • Interconnects to any Security Alarm Panel that can accept a dry N.C. or N.O.