User Guide

EP Series User Programming Guide 12
Doors (Cont.)
Door Status Alarm Output
Sets the actions of a door contact on the door. The door contact must be enabled to use these functions.
1. Check Forced Door to trigger the
door alarm output if the door opens,
but no access was granted.
2. Check Held Door to trigger the door
alarm output if the door is held open
longer than the Held Open Time.
3. Select Energized or De-energized
for the Default State of the Door
Status Alarm Output.
4. Select an Output to use for the Door
Status Alarm Output.
5. Click to enable an Alarm Shunt
output to operate when access is
granted to the secured door.
6. Select Energized or De-energized
for the Default State of the Alarm
Shunt Output.
7. Select an Output to use for the
Alarm Shunt Output.
Threat Level
1. Select the highest Threat Level
allowed before the door will
automatically lock.
» NOTE: An unlocked door will lock if the
System Threat Level is greater than the
Door Threat Level; including doors that are
unlocked by schedule.
» NOTE: The Dashboard M-Unlock and
E-Unlock may be used to unlock a door that
has been locked due to elevated system
Threat Level.
2. Check Ignore REX to ignore input
from a Rex button if the current
System Threat Level is higher than the Door Threat Level.
Anti-Passback
1. Check to enable Timed Anti Passback. Select a time in seconds to disable a credential after it has been used to grant
access.
2. Check to enable Room Anti Passback. Select a time in seconds to disable access to a room after access has been
granted to the room.