User Guide

47 EP Series User Programming Guide
Save & Reboot
Save and Reboot the system.
Reboot
1. Click Reboot to force a data save on the Controller and restart the system.
2. Enter an super administrator password and click OK.
» NOTE: Without battery backup, if the system is powered down prior
to saving data, data will be lost. The EP series performs an automatic
backup every 1.5 hours and/or upon A/C loss when on battery to
permanent memory. If programming prior to eld installation, manual
backup must be performed via the Save and Reboot tab (on user
portal interface) to save data.
Factory Default
Factory Default will erase ALL Card Holder data, logs, IP settings and license key.
» !! IMPORTANT !!: Write down the license
key prior to performing a factory default.
» WARNING: It will take 3-5 minutes to
factory default a system. DO NOT power
down when performing a factory default.
Make sure the electrical power source is
reliable when performing a factory default.
Any loss of power during a factory default
can damage your system.
Resetting to Factory Defaults
1. After heeding the above warnings,
click Factory Default.
2. Enter an Super Administrator
Password and click OK.
3. Wait 3-5 minutes for the system to
reset and reboot.
4. Enter the license key when the
system restarts.
» Note: If needed you can go to e3upgrade.
com to recover a license key.