Installation Manual

ManualsBrandsLinear ManualsBurglar Alarms100 Feet Vehicle Sensor Exit Wand

Gates that Open, LLC • 3121 Hartseld Road • Tallahassee, Florida 32303

1-800-543-GATE (4283) • Technical Support 1-800-543-1236

www.gtoaccess.com

When an EXIT WAND is in use, the automatic gate opener could be activated

by a child on a bicycle or other metal play equipment. This Product is not

recommended for applications exposed to children.

WARNING

SENSOR with 50, 100 or 150

feet of Direct Burial Cable

Warning Signs (2)

Wire Nuts (2)

Battery Connection Wires (2)

Double Spade

Connectors (2)

Ty-Wraps (4)

Wire Clamp

WARNING

GATE OPENING

SENSOR IN USE

The Automatic Gate Opener is activated when a

vehicle comes within range of the sensor buried

along side the driveway and could possibly be

activated by a child on a bicycle, tricycle or other

metal play equipment.

Parts Identication:

WARNING

RWINST01PRO

rev-12/28/11

EXIT WAND

PROFESSIONAL RESIDENTIAL

INSTALLATION MANUAL

ACCESS

SYSTEMS

Summary of content (4 pages)

PAGE 1
ACCESS SYSTEMS PROFESSIONAL RESIDENTIAL EXIT WAND INSTALLATION MANUAL WARNING When an EXIT WAND is in use, the automatic gate opener could be activated by a child on a bicycle or other metal play equipment. This Product is not recommended for applications exposed to children.
PAGE 2
INSTALLATION OVERVIEW Gate Opener Control Box Open Gate Outside Sensor Range Minimum of 25 feet 12” PVC conduit in ground and up to control box recommended • The SENSOR is designed to detect ironbased metal in motion. • The SENSOR’s ability to detect iron-based metal objects is based on the mass, velocity and proximity of the object to the sensor. SENSOR: 2 feet from driveway edge and 1 foot in ground 24” SENSOR: 2 ft. from Driveway (max) and12 in. deep RANGE: 12 ft.
PAGE 3
TURN GATE OPENER OFF WIRING DIAGRAM EXAMPLES NOTE: Power Input Connections Not Shown. 4. (See gate instruction manual for complete instructions) Connect the BLACK to the terminal labeled COMMON, and the BLUE wire to terminal in STEP 3 to open gate. ALARM Double Spade Connectors included with SENSOR Battery Cable RED (+) ON LEARN WHT BLU ORG GRN SEQ1 SEQ2 R ACCESSORY Connect the Black wire from the SENSOR CABLE to one of the COMMON terminals on the opener control board.
PAGE 4
TECHNICAL SPECIFICATIONS: • • • • Power Supply: 8-26 Vac - 11-30 Vdc • Current consumption 3 mA. typical • Relay rating: 1 amp max, 30 Vdc Relay Pulse Time: 2 seconds Operating Temperature: 25°F (-14°C) to 125°F (-69°C), or battery operating temperature Dimensions: 1¾” (44.5 mm) diameter x 16½” (42cm) long TROUBLESHOOTING: Make sure all connections are correct • • • Disconnect the power (battery) to the WAND.