Owner's Manual

ManualsBrandsLinear ManualsMisc ElectronicsLinear H634

The H634 Cable/DSL Router with 4-port Switch connects multiple

computers to a DSL or cable modem. “Plug and play” installation is easy when using

the H628 data hub. The H634 is

IEEE 802.3u 100 Base-TX Fast

Ethernet compliant, IEEE 802.3

10 Base-T compliant and has

activity LEDs for network status

and diagnosis. The H634 can

connect with up to four client

computers directly. Up to 253

computers can be connected

by using additional Ethernet

switches (H638) or hubs.

Typical Telephone DSL Installation

Wiring the H634 Router

• Use only Category 5e unshielded twisted-pair cable for maximum

performance.

• When connecting to an H628 or a network device directly,

use straight through or crossover RJ-45 cables. All ports will

automatically detect the cable type.

• Each run to a network device should be less than 100 meters

(328 feet).

LED Indicators

• PWR lights when power from transformer is present.

• RDY lights when router is ready for packet data from the WAN.

• WAN lights when wide area network packets are sent or received.

• 1-2-3-4 lights when packet data is being sent to, or received from,

the client computers or additional hubs or switches.

Speciﬁ cations: Typical @ 25°C ± 5°C

Compliance

IEEE 802.3u

IEEE 802.3

100 Base-TX, 10 Base-T and N-way

auto-negotiation

Network Interface

RJ-45 ports 4 to client computers or hub/switch

RJ-45 WAN 1 from DSL/cable modem

Max Cable Length

CAT-5e (UTP) 100 meters (328 feet)

LED Indicators

router & ports PWR, RDY, WAN, Ports 1, 2, 3, & 4

Environmental

operating

temperature

0°C to 40°C

Power Supply

output current 1A maximum

output voltage 7.5 VDC

input power 120 VAC

OpenHouse

Cable/DSL Router

ATTACH THE ROUTER TO

THE MB-56 MOUNTING PLATE

WITH THE DOUBLE-SIDED

FOAM TAPE SUPPLIED

ATTACH

HORIZONTAL

OR ATTACH

VERTICAL

PULL THE SNAP LATCH

PLUNGER OUT THEN

HOOK THE MOUNTING

PLATE INTO THE GRID

FROM THE BOTTOM

PRESS THE SNAP

LATCH PLUNGER

TO LOCK THE

PLATE

Typical Broadband Cable Installation

Using Additional Hubs or Switches for Expansion

• Use only Category 5e unshielded twisted-pair cable for maximum

performance.

• When connecting additional hubs or switches, use a straight

through or crossover RJ-45 Category 5e cable. Category 5 patch

cords may be used for short interconnections.

• The cable length between any two hubs or switches cannot

exceed 100 meters (328 feet).

• All additional hubs or switches used must be self-powered.

Declaration of Conformity

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION

IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE

MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST

ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE

THAT MAY CAUSE UNDESIRED OPERATION.

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used according to the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which if found by turning the

equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet other than the receiver’s outlet.

• Consult a dealer or an experienced radio/TV technician for assistance.

4 3 2 1 WAN DC IN

From

DSL modem

computers

7.5 VDC

from power

adapter

4321

WAN

H628

Cat-5

Termination

Hub

DC Input

from 7.5 VDC

Power Adapter

DSL connection

from telephone

company

To data jacks in

remote wall plates.

Connect up to four

computers or external

hubs or switches.

Many modems may be

mounted by using an MB-55

or MB-56 mounting bracket

DSL modem

IN OUT

H634

Cable/DSL

Router