User Manual

- 2 -
Copyright © 2015 Nortek Security & Control LLC 10004403 X3
BASIC OPERATION
When triggered, the siren/strobe will trigger for 30 seconds (default setting).
During that time the siren will emit a very loud pulsating audible alarm at
105 db. The integrated strobe light will also fl ash during the 30 seconds.
✘ CAUTION: This is an extremely loud siren, do not place it near your ear.
LED Indication
The LED on the siren/strobe will not be on during normal operation.
Remote Control
The siren/strobe will respond to BASIC and BINARY commands that are part
of the Z-Wave system. Refer to your Controller’s instructions as to whether your
Controller can transmit those commands.
CONFIGURATION
The siren/strobe supports the Confi guration command. The siren/strobe can
be confi gured to operate slightly differently than how it works when you fi rst
install it. Using the Confi guration command you can confi gure the following:
Parameter 0: Siren / Strobe Mode
By default, the siren and strobe will activate when turned on. To activate the
Siren only, set parameter 0 to 1. For strobe only set to 2.
• Parameter No: 0
• Length: 1 Byte
• Valid Values = 0 (default) or 1 or 2. Default is 0.
Parameter 1: Auto Stop Time
By default the auto stop time is 30 seconds. Setting parameter 1 to 1 will
increase the time to 60 seconds. Changing it to 2 will increase the stop time
to 120 seconds. Setting the stop time to 3 will turn off the auto stop and will
require a command from the Controller to turn the siren/strobe off.
• Parameter No: 1
• Length: 1 Byte
• Valid Values = 0 or 1 or 2 or 3. Default is 0.
Default Setting
Each confi guration Parameter can be set to its default setting by setting the
default bit in the Confi guration Set command. See your Controller’s instructions
on how to do this (and if it supports it).
All confi guration commands will be reset to their default state when the siren/
strobe is excluded from the Z-Wave network by using the Controller to reset
the node.
SPECIFICATIONS
Power Supply 4 Type “AA” Alkaline batteries
Frequency 908.42 MHz
Audible Alarm >105 dB @ 3 feet
Strobe White LED with red lens
Operating Temp 5°F~140°F / -15°C~ 60°C
Repeater No
Range Up to 100 feet line of sight between the
Z-Wave Controller and/or the closest Z-Wave
Repeater
INTEROPERABILITY WITH Z-WAVE DEVICES
A Z-Wave network can integrate devices of various classes, and these devices
can be made by different manufacturers, just as the siren/strobe can be
incorporated into existing Z-Wave networks.
PACKAGE CONTENTS
• Siren/strobe with wall mounting bracket
• 4 Type “AA” Alkaline batteries
• Double-sided mounting tape
• 2 mounting screws
• Installation manual
REGULATORY INFORMATION
The siren/strobe is certifi ed to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference received that
may cause undesired operation.
FCC Notice
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician to help.
• Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment
IC Notice
This Class B digital apparatus complies with Canadian ICES-003
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le présent appareil est conforme aux
CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
RETAIL LIMITED WARRANTY AND REPAIR POLICY
Nortek Security & Control LLC (the Company) warrants its products to be free from defects in material and workmanship for
a period of (1) year from the date of purchase. The Company within said period shall at its option, either repair or replace free
of charge, any product or part thereof found, upon the Company’s inspection, to be so defective, and will return the repaired or
replaced product to the purchaser at Company’s expense.
The Company’s maximum liability hereunder is limited to the purchased price of the product. There are no obligations or
liabilities on the part of Nortek Security & Control LLC for consequential damages arising out of or in connection with use or
performance of the product or other indirect damages with respect to loss of property, revenue, or profi t, or cost of removal,
installation or reinstallation.
All implied warranties, including implied warranties for merchantability and implied warranties for fi tness, are valid only until
warranty expiration date from date of purchase. This Nortek Security & Control LLC Warranty is in lieu of all other warranties
express or implied. Some states and countries do not allow limitations or how long an implied warranty lasts or the exclusion or
limitation or incidental or consequential damages, so the above exclusions may not apply. The Nortek Security & Control LLC
warranty gives specifi c legal rights in addition to other rights, which may exist and vary from state to state and country to country.
A. All customers are required to call Technical Support to troubleshoot a product before it is eligible for return. Call 1-855-546-3279
to talk with a technical support engineer. If the product is deemed defective they will provide a Tech Ticket as a reference for
return.
B. All products returned for warranty repair service or reported in a warranty claim, per the guidelines above, require a Return
Product Authorization Number (RPA#). Contact Returns at 1-855-546-3351 or send an e-mail to returns
[e-mail] for an RPA#. Proof of purchase and a Tech Ticket are required to receive a RPA#.
C. Devices must be sent to the Company at owner’s expense and be accompanied with statement of defect and proof of
purchase.
D. For products requiring return to Nortek Security & Control LLC, specifi c packing, labeling, shipping and tracking policies apply.
These will be provided and reviewed as needed before product is returned.
E. Product may be inspected and tested by Nortek Security & Control LLC and if found to be in working condition and not
defective will be returned to the customer in the condition received.
F. The user is responsible for all labor costs associated with removing and reinstalling the product. Nortek Security & Control
LLC, at its option and per the guidelines above, will repair or replace the defective product.
G. Replacements will be made from refurbished stock. If an exact replacement is not available Nortek Security & Control LLC,
at its option will select the nearest equivalent product. The user is responsible for freight charges to Nortek Security & Control
LLC.
H. Nortek Security & Control LLC will return warranted repaired or ship replacements by UPS Ground or an equivalent service.
A customer may pay the additional costs for second day or next-day service.
THERE IS NO PROVISION FOR LABOR COST OR OTHER REIMBURSEMENTS OF ANY KIND. IN NO EVENT WILL
NORTEK SECURITY & CONTROL ACCEPT RETURNS OF ANY PRODUCT THAT HAS BEEN DISCONTINUED OR THAT
HAS BEEN REVISED OR UPDATED.
Defective products are covered by the warranty with the following exceptions:
1. Failures due to product abuse, negligence, non-factory authorized modifi cations, improper installation, improper use, and
electrical surge including damage from lightning, water damage or other damage due to natural disasters are not covered by
the warranty.
2. The warranty shall also be voided by any tampering with the date code, labels or other markings on the product.
3. The warranty does not apply to: (i) damage incurred in shipping or handling; (ii) damage caused by disaster such as fi re, fl ood,
wind, earthquake or lightning; (iii) damage due to causes beyond the control of Nortek Security & Control such as excessive
voltage, mechanical shock or water damage; (iv) damage caused by unauthorized attachment, alterations, modifi cations
or foreign objects being used with or in conjunction with the Product; (v) damage caused by peripherals, sensors or other
products used in connection with the Products (except for Products supplied by Nortek Security & Control); (vi) defects caused
by failure to provide a suitable installation environment for the Products; (viii) damage caused by use of the Products for
purposes other than those for which they were designed; (ix) damage from improper maintenance; (x) damage arising out of
any other abuse, mishandling or improper application of the Products; (xi) damage resulting from disassembly or repair in such
a manner as to adversely affect performance or prevent adequate inspection or testing to verify any warranty claim.
4. Products that are damaged in transit to Nortek Security & Control LLC due to improper packaging or by the carrier (shipping
company) will not be covered under the warranty. If the product was damaged or lost by the carrier, it is the sender’s
responsibility to create a claim against the carrier.
PRINTER’S INSTRUCTIONS:
INSTR, INSTL, WA105DBZ, GO CONTROL; P/N: 10004403 X3; INK: BLACK; MATERIAL: 20# MEAD BOND; SIZE: 8.500” x 11.000”; TOLERANCE: ± .125”; SCALE: 1-1; PAGE 2 OF 2