User guide

Page
11.
36. Starting with the back 6 bolts, remove the
10 mm bolts on the supercharger cover with a
socket and extension.
35. Loosen the engine cradle nuts such
that you have roughly a 1 inch (25 mm) gap
between the nut and the subframe. You should
still have several turns of engagement on the
threads on each nut. Do not remove the nuts
from the studs.
NOTE: If you are using a vehicle hoist, lower
the vehicle back down so you can now work in
the engine compartment area.
33. Using a 13 mm socket and the 6”
extension, remove the sway-bar bushing to
cradle bracket bolts (2 per side) and then
remove the brackets from both sides. Allow the
sway bar to swivel down but do not remove the
sway-bar.
34. Using a 21 mm socket, loosen the four
engine cradle retaining nuts on both sides.