User guide

Page
77. Install the boost control solenoid bracket
assembly onto the front cover. Using a 10 mm
socket, torque the fastener to 10 Nm (89 lb-in).
Replace all vacuum hoses.
NOTE: Refer to the diagram on page 35 for the
vacuum routing diagram.
78. Install the purge solenoid onto the front
cover. Using a 10 mm socket, torque the
fastener to 10 Nm (89 lb-in).
80. Install the throttle body on the
supercharger front cover. Using a 10 mm
socket, torque the four (4) bolts to 10 Nm (89
lb-in).
22.
79. Install the inlet air pressure sensor onto
the front cover. Using a 10 mm socket, torque
the fastener to 10 Nm (89 lb-in). Plug connector
back into inlet air pressure sensor.