User guide

Page
124. You can purchase vehicle programming
hardware and software from LPE, you can send
in your ECM for us to calibrate or you can have
a local tuning shop calibration your vehicle.
NOTE - some pulley combinations require
ignition timing changes in order to operate with
pump gas. The increased boost levels risk
damaging your engine if the correct calibration
changes are not made.
123. Program the vehicle’s engine control
module (ECM) as required for the combination
of parts on your vehicle.
The different pulley ratio combinations will
require different levels of calibration changes
but all combinations require some level of
calibration changes.
122. Re-install the engine sight shield (engine
cover) by pushing down on the cover to secure
it to the mounting posts.
33.
121. Connect the mass air ow sensor
connector.