ZL1 Camaro Intercooler Fluid Reservoir Kit PN: L300152012 Revision - 1.2 Lingenfelter Performance Engineering 1557 Winchester Road Decatur, IN 46733 (260) 724-2552 (260) 724-8761 fax www.lingenfelter.
Parts List LPE Intercooler Fluid Reservoir Kit (PN: L300152012) • • • • • # 1 1 1 3 1 1 1 Description High capacity intercooler reservoir Pressure Cap, 16 psi 90 degree heater hose Constant tension clamp, for 15/16” OD hose 22.
1. Install the stud adapter (red arrow) onto the rear airbox stud. Remove the backing paper off of the foam mounting ring (yellow arrow) and slide the ring over the stud adapter. 2. Install the grommet into the hole forward and below the rear airbox stud. 3. Using Teflon thread sealant and a 7/8” wrench, install the 90 degree fitting into the bottom of the coolant reservoir. The open end of the 90 degree fitting should be pointed towards the front of the vehicle . 4.
5. Locate the supercharger coolant pump, which can be found just below and in front of the damper. This pump will be connected to the coolant reservoir in the following steps. 6. Before the LPE supplied 90 degree hose can be installed, the short part of the hose after the 90 degree bend must be cut down so that it is just long enough for the constant tension clamp to secure the hose to the pump. Use a hose cutter to cut the hose. 7.
9. The stock charge air cooler coolant hoses are held together by two pieces of tape. The hoses need to be separated so that one can be modified later. Using a razor blade (or equivalent), cut the tape and separate the hoses, as shown by the dashed yellow line in the adjacent illustration. CAUTION: Take care not to cut the stock hoses with the razor blade. 10.
13. After applying silicone lubricant to the inside of the hose, attach the hose to the 90 degree fitting. Using a set of Oeticker clamp pliers (or equivalent), secure the hose to the fitting with the supplied Oetiker clamp. 14. Pull the other end of the hose off of the coolant reservoir and slide a constant tension clamp onto the hose.
17. Reinstall the end of the hose to the fitting just below the radiator support. 18. Add coolant (should be a 50/50 mixture of DEX-COOL antifreeze and tap water or distilled water) into the reservoir. Fill the reservoir until the fluid reaches the parting line on the outside of the reservoir. The coolant reservoir has a fluid capacity of roughly 4 liters. Install the 16 psi pressure cap (PN: L300170016). Installation of the LPE ZL1 Camaro Intercooler Fluid Reservoir Kit is now complete.