Manual

ManualsBrandsLingenfelter ManualsAccessories for airL650400493 Lingenfelter F-Body SuperTube Air Intake 1993 v4.2

1993 5.7L LT1 V8

Chevrolet Camaro & Pontiac Firebird

Lingenfelter SuperTube Air Intake System

Installation Instructions

L650400493

50 state emissions legal (E.O. D-333-15)

Lingenfelter Performance Engineering

1557 Winchester Road

Decatur, IN 46733

(260) 724-2552

(260) 724-0422 fax

www.lingenfelter.com

Release date 18-May-2010

Revision - 4.2

Summary of content (4 pages)

PAGE 1
993 5.7L LT1 V8 Chevrolet Camaro & Pontiac Firebird Lingenfelter SuperTube Air Intake System Installation Instructions L650400493 50 state emissions legal (E.O. D-333-15) Revision - 4.2 Lingenfelter Performance Engineering 1557 Winchester Road Decatur, IN 46733 (260) 724-2552 (260) 724-0422 fax www.lingenfelter.
PAGE 2
# Part Number 1 LN0040_001 1 L660010493 1 LN0041_005 3 AV14010 4 6483 1 1 1 Parts List Description LPE plastic air intake tube LPE high flow air filter with hose clamp plastic block-off plate plastic fasteners hook and loop tape, inches (for Firebird only) EO decal LPE decal Installation instructions Recommended Tools • flat-head screwdriver • Phillips-head screwdriver (for Firebird installations only) • 5/16" socket • 10 mm socket • ratchet • WD40 or similar lubricant • electric drill • 5/16" dri
PAGE 3
• • • • • • • • • • • Remove the air intake from the ribbed rubber intake elbow (leave the elbow mounted to the vehicle). In the space below where the stock air filter box was mounted, you will see a small black plastic hollow air intake box that fed air to the air filter assembly. On Firebirds, the headlamp door module is the device with wires leading to it that is mounted to this hollow air intake. The hollow box is secured to the vehicle by a plastic fastener.
PAGE 4
• • • • • On Firebirds - using the supplied hook and loop tape - mount the headlight door module to the horizontal subframe area on top of and next to the block off plate. Leave the two pieces of hook and loop tape fastened to each other. Remove the tape backing from one side and attach the tape along one edge of the module.