User Manual

25. Cut the shipping tie-strap from around
the tank and the Oetiker clamp from around
the ller neck tube on the tank side. NOTE:
the shipping strap is only for shipping and
need not be replaced once the tank is in-
stalled in the vehicle.
26. Pull back the rubber ller-tube covering
hose and undo the snaps around the
perimeter of the tank holding the fuel-tank
cover in place. Remove the cover.
NOTE: IT IS IMPERATIVE THAT CARE IS TAKEN
WITH THE FUEL-PUMP MODULE IN THE FOLLOWING
STEPS - THIS PART IS ONLY SOLD AS A COMPLETE
ASSEMBLY
27. Pull the sliding tabs on the side of the
fuel hose on top of the fuel pump module
and disconnect the hose.
28. Disconnect the wiring harness clips from
the fuel-pump module.
Page 7 of 17