Service Manual

Table Of Contents

1ST MATE KIT - MERCURY

DRAFT

COPY

DRAFT

COPY

DRAFT

COPY

DRAFT

COPY

DRAFT

COPY

DRAFT

COPY

DRAFT

COPY

Hub Installation

WARNING

Before working around electrical system components, disconnect the battery cables from the battery to prevent injury or

damage to the electrical system due to an accidental short circuit.

1. Place the hub so that the antenna is at least 50.8 mm (2.00 in.) from other electronic or magnetic equipment including

Chartplotters, VHF radios, GPS receivers, and antennas.

2. Use the following dimensions to select the desired location for the hub. Mount the hub on a bulkhead or panel near the

helm where it will be protected from the elements.

IMPORTANT: Minimum panel depth must be greater than 20 mm (0.79 in.). Use a 1/8 bit to drill pilot holes for the

fasteners. Do not drill through the panel. Drawing measurements are for reference only. Do not use for a drilling

template.

Not a template

a - 123.75 mm (4.872 in.)

b - 72 mm (2.834 in.)

c - 157.60 mm (6.204 in.)

d - 146.60 mm (5.771 in.)

IMPORTANT: Use the supplied fasteners to mount the hub on a panel or bulkhead with the front of the hub facing

forward or aft, so that it is perpendicular to the vessel's center line. Do not over tighten the mounting fasteners.

70268

Recommended mounting orientation

3. Connect the NMEA 2000 network connector to the hub.

4. Connect the 14‑pin harness connector to the hub.

123.75 mm (4.872 in.)

72 mm (2.834 in.)

157.60 mm (6.204 in.)

146.60 mm (5.771 in.)

69896