Full Product Manual

thoroughly flush the affected area with plenty of clean water and seek immediate medical attention.
Function
The LED light will switch on during twilight or darkness when the motion detector
detects infrared radiation given off by people passing by.
Note: Once the light is activated by the motion detector, any subsequent detection will restart the timed
period again from the beginning.
Note: Regularly clean the motion detector to ensure proper functionality (refer to “Cleaning and Care“).
Installation
1. Loosen the clip
4
to remove the battery cover.
2. Insert two AA batteries (not included) to the battery compartment
3
in correct direction. The correct
polarity is shown inside the battery compartment.
3. Put back the battery cover and close it.
4. Slide the function switch
2
to the desired position.
Position 1: light is always on
Position 0: light is always off
Position Auto: light will be automatically switched on for approx 45 seconds when motion is detected.
5. Put the product on an even and sturdy surface to illuminate the desired area.
The motion detector
1
has a detection range of max. 16.4ftwith a detection angle of 110º
Replacing the batteries
1. Loosen the clip
4
to remove the battery cover.
2. Remove the old batteries from the battery compartment
3
, and replace with new batteries of the same
type. Be sure to insert the batteries in correct direction. The correct polarity is shown inside the battery
compartment.
3. Put back the battery cover and close it.