Installation Guide

ManualsBrandsLink2Home ManualsLandscape Flood Lights & SpotlightsSuper Bright Black 220-Lumen Motion Activated Outdoor Dual Head LED 6500K Battery Powered Landscape Flood Light

Motion LED Security Light Battery Operated

EM-BL268B

Introduction

We congratulate you on the purchase of your LED Sensor Light. You have chosen a high quality product.

Before using your LED Sensor Light, please familiarize yourself with the instructions and safety

information below. Only use the product as described and for the specified applications.

This product is intended to illuminate indoor or outdoor areas for private use and is not suitable for

commercial use or for use in other applications.

Technical Data

LED Type: 12*2835

Battery: 3*1.5v DC AA(exclude)

Motion sensor angle: 140º

Motion detection range: approx.26.2ft - 32.8ft

Time setting: approx. 3seconds to 7min (+/-10%)

Lumen: 220LM (+/-10%)

Protection type: IP44 (splash-proof)

General safety instructions

1. Children should not be allowed to play with the product. Cleaning and user maintenance should not be

performed by children without adult supervision.

2. Never leave children unsupervised with the packaging material. The packaging material represents a

danger of suffocation.

3. Keep batteries/rechargeable batteries out of reach of children. If accidentally swallowed, seek

immediate medical attention.

4. Do not use this product if you notice any damage

5. The illuminants are not replaceable. If the illuminants fail, the entire product must be replaced.

6. Never recharge non-rechargeable batteries. Do not short-circuit batteries/rechargeable batteries

and/or open them as overheating, fire or busting can occur.

7. Do not exert mechanical loads to batteries/rechargeable batteries.

8. Only use the same type of batteries/rechargeable batteries. Do not mix used and new

batteries/rechargeable batteries.

9. Remove the batteries/rechargeable batteries if the product will not be used for a long period of time.

10. When inserting batteries, ensure the correct polarity. (This is shown inside the battery compartment)

11. Remove drained batteries/rechargeable batteries from the product immediately.

12. Leaking or damaged batteries/rechargeable batteries can cause burns on contact with the skin. Wear

suitable protective gloves at all times if such an event occurs. In the event of contact with battery acid,

thoroughly flush the affected area with plenty of clean water and seek immediate medical attention.

Summary of content (4 pages)

PAGE 1
Motion LED Security Light Battery Operated EM-BL268B Introduction. We congratulate you on the purchase of your LED Sensor Light. You have chosen a high quality product. Before using your LED Sensor Light, please familiarize yourself with the instructions and safety information below. Only use the product as described and for the specified applications. This product is intended to illuminate indoor or outdoor areas for private use and is not suitable for commercial use or for use in other applications.
PAGE 2
Function The LED light will switch on during twilight or darkness when the motion detector detects infrared radiation given off by people passing by. User can turn the control knob TIME to adjust the duration of the illumination from approx. 3 seconds to 7 minutes (+/-10%). User can turn the control knob LUX to adjust the daylight level at which to activate the motion detector.
PAGE 3
12. Turn the control knob LUX to adjust the daylight level: At the position react at night. In the position , the motion detector will only , the motion detector will respond at daylight levels. 2 □ 3 □ Replacing the batteries □ □ 1. Loosen the screw 1 and remove the main unit from the mounting plate 2 . □ 2. Remove the battery cover 3 and take out the drained batteries from the battery compartment, and replace with new batteries of the same type.
PAGE 4
Troubleshooting Problem Cause Solution The light does not switch on Motion detector is dirty Clean motion detector during nighttime LUX control is not properly set Turn LUX control to increase LUX level.