How-To Guide

Page
2
of
4 Ref: KDB 594280 D02 U-NII / RSS-247article 6.4(4).
Requiremen t Answer
Third Party Access Control
1. Explain if any third parties have the
capability to operate a U.S./Canada -
sold device on any other regulatory
domain, frequencies, or in any manner
that may allow the device to operate in
violation of the device’s authorization if
activated in the U.S./Canada.
Only Grantee can release or make changes
to the software/firmware
2. Describe, if the device permits third-party
software or firmware installation, what
mechanisms are provided by the
manufacturer to permit integration of
such functions while ensuring that the
RF parameters of the device cannot be
operated outside its authorization for
operation in the U.S./Canada. In the
description include what controls and/or
agreements are in place with providers
of third-party functionality to ensure the
devices’ underlying RF parameters are
unchanged and how the manufacturer
verifies the functionality.
No, refer to the answers #1, 2, and 3 under
General Description
3. For Certified Transmitter modular devices,
describe how the module grantee
ensures that host manufacturers fully
comply with these software security
requirements for U-NII devices. If the
module is controlled through driver
software loaded in the host, describe
how the drivers are controlled and
managed such that the modular
transmitter RF parameters are not
modified outside the grant o f
authorization.
RF parameters are written in a special location
by factory tool. The RF partition can’t changed
by software update. Manufactures do NOT have
source code of the factory tool, nor can they
change any RF parameters.
4.Auto-discontinue mechanism description The automatic disconnection mechanism was
set up before the factory. The product
automatically stops transmission when the
operation fails or when no information is
transmitted.
This section is required for devices which have a “User Interface” (UI) to configure the device in a
manner that may impact the operational parameter. The operation description must address if the
device supports any of the country code configurations or peer-peer mode communications discussed
in KDB 594280 D01.
SOFTWARE CONFIGURATION DESCRIPTION
Requirement Answer
R
CONFIGURATION
GUIDE
1. Describe the user configurations permitted
through the UI. If different levels of access
are permitted for professional installers,
system i ntegrators or end-users, describe
the differences.
This product is a module and does not support
UI operations
a) What parameters are viewable and
configurable by different parties?
None that affects compliance
b) What parameters are accessible o
r
None that affects compliance