Owner's Manual

Package Contents

• One Linksys Instant Broadband™ EtherFast

Cable/DSL Voice Enabler

• One power adapter

• One Net2Phone/Linksys Rechargeable Calling Card (Not Shown)

• One user guide and registration card

System Requirements

• One Available RJ-45 10/100 Port on Your Router, Switch or Hub (connect-

ed to the Internet)

• One Standard Touch-tone Telephone Set

• Microsoft Internet Explorer 4.0 or later, or Netscape Navigator 4.0 or later.

(5.0 and 4.7, respectively, are strongly recommended.)

EtherFast

Cable/DSL Voice Enabler powered by Net2Phone

Getting to Know the Cable/DSL

Voice Enabler

The Cable/DSL Voice Enabler’s Rear Panel

The rear panel of the Voice Enabler is where all of the Voice Enabler’s con-

nections are made.

Uplink The Uplink Port is where you uplink to your

router, switch or hub. Connect one end of a UTP

Category 5 cable to the Voice Enabler’s Uplink

port. Connect the other end of the cable to the

appropriate port on the back of your router, switch

or hub (which is connected to the Internet).

Crossover Switch The Crossover Switch (X II) toggles the Uplink

port between crossover mode (X) and straight-

through mode (II). See the diagram below to

determine the position the switch should be in for

your situation.

NNoottee::

The diagram above is for reference purpos-

es only. Every network is different. If you do not

make a connection to the Voice Enabler by using

the settings above, change the position of the

Crossover Switch.

Instant Broadband

Series