Owner's Manual

Phone The Phone Port is where you will connect your
standard telephone.
Power The Power Port is where you will connect the
included AC Power adapter.
Reset Button See the section below concerning the Voice
Enabler’s Reset Button.
The Reset Button
*
Briefly pressing the Reset Button will refresh the Voice Enabler’s
connections, potentially clearing any jammed links.
Pressing the Reset Button and holding it in for a few seconds will
clear all of the Voice Enabler’s data and restore the factory defaults. By reset-
ting the Voice Enabler, you run the risk of creating conflicts between your PCs’
actual IP Addresses and what the Voice Enabler thinks their IP Addresses should
be. You may be forced to reboot the entire system(s).
If your Voice Enabler locks up, simply power it down for 3 to 5 seconds by
removing the power cable from the Voice Enabler’s Power Port.
Et erFast
®
Cable/DSL Voice E abler powered by Net2P o e
SM
6
I sta t Broadba d
TM
Series
5
Cable/DSL Voice Enabler ’s Front Panel LEDs
Power Green. The Power LED illuminates when the Voice enabler
is powered on.
Diag Red. The Diag LED illuminates when the Voice Enabler
goes through its self-diagnosis mode during boot-up. It will
turn off upon successful completion of the diagnosis. If this
LED stays on for an abnormally long period of time, refer
to the Troubleshooting section.
In Use
Net2Phone Green. The Net2Phone LED illuminates when there is an
open phone connection.
Link/Act Green. The Link/Act LED serves two purposes. If the LED
is continuously illuminated, the Voice Enabler is successful-
ly connected to a device through the Uplink port. If the
LED is flickering, the Voice enabler is actively sending or
receiving data.
Full/Col Green. The Full/Col LED also serves two purposes. If this
LED is continuously illuminated, the connection made
through the corresponding port is successfully running in
Full Duplex mode. If the LED is off, the port is operating at
half duplex. If the LED is flickering, the connection is
experiencing collisions. Infrequent collisions are normal. If
this LED is flickering too often, there may be a problem
with your connection. Check the Troubleshooting section if
you think there is a problem.
100 Orange. The 100 LED illuminates when a successful
100Mbps connection is made through the corresponding
port. If the LED is off, the port is operating at 10Mbps.