Operation Manual

Chapter 2
Network Setup and Extender Connections
14
Media Center Extender
14
Media Center Extender
Power on the Media Center Extender
NOTE: Power on your TV.
DMA2200
Plug the Media Center Extender’s power cord connector to the unit’s
power port on the back panel. Plug the cord into an electrical outlet.
DMA2200
FOR HOME OFFICE USE
Tested To Comply
With FCC Standards
S-Video
SCART IN/OUT
Composite
RESET
Power Switch
DMA2200 Power Cord and Switch
There is also an on/off power switch just above the power port. Power on
the unit before starting Device Configuration.
DMA2100
This unit ships with the correct power clip for your region.
DMA2100
Reset /
Default
HDMI, the HDMI logo is a trademark or registered trademarks of HDMI Licensing, LLC.
S-VIDEO
VIDEO
Pb
Pr
Y
RIGHT
DIGITAL
ADUIO
ETHERNET
10/100
LEFT ANALOG AUDIO
s-PDIF
Tested To Comply
With FCC Standards
Contains FCC:N89-WM821-LS
FOR HOME OFFICE USE
COMPONENT
VIDEO
DMA2100 Power Cord
Plug the Media Center Extender’s power cord connector to the unit’s
power port on the back panel. Plug the cord into an electrical outlet.
Regional Power adapters
If needed, pull out the clip covering the power port connector. You can
then snap in the appropriate power clip that matches your main power
outlet. Power clips are used in Europe and Asia.