Quick Start Manual

173
Device Installation
Power Device
NOTE: Power on your TV. The initial start up of the Extender could
take up to one (1) minute.
Power on the Media Centre Extender
DMA2200
Plug the Media Centre Extender’s power
cord connector into the unit’s power
port on the back panel. Plug the cord
into an electrical outlet.
There is also an on/off power switch just
above the power port. Power on the unit
before starting Device Configuration.
DMA2100
This unit ships with the correct power
clips for your region. If needed, pull
out the clip covering the power port
connector. You can then snap in the
appropriate power clip that matches
your Main power outlet.
Plug the Media Centre Extender’s power
cord connector to the unit’s power port
on the back panel. Plug the cord into an
electrical outlet.
NOTE: There is an IR sensor on the front of the Media Centre
Extender. Make sure the front panel is visible for the remote
control.
DMA2100 DMA2200
Reset /
Default
HDMI, the HDMI logo is a trademark or registered
Tested To Com
ply
With FC
C Standards
Conta
ins FCC:N89-WM821
-LS
FOR HOME OFFICE USE
FOR HOME OFFICE USE
Tested To Comply
With FCC Standards
SCART IN/OUT
RESET
Power Cord Connection
DMA2100 DMA2200
Reset /
Default
HDMI, the HDMI logo is a trademark or registered
Tested To Com
ply
With FC
C Standards
Conta
ins FCC:N89-WM821
-LS
FOR HOME OFFICE USE
FOR HOME OFFICE USE
Tested To Comply
With FCC Standards
SCART IN/OUT
RESET
Power Cord Connection
DMA 2100 Power ClipsDMA 2100 Power Clips