User Guide

Product Overview - Player
5
Player/Wireless-N Music Extender
Wireless Home Audio
Product Overview - Player
Before You Begin
This User Guide is intended to provide details on the
product hardware, user interface, and use of the product.
For initial installation instructions, please refer to the Quick
Installation Guide included with your product.
Features
Tos-Link, S/PDIF, RCA and 3.5mm Audio Outputs •
Draft-N Wireless with Internal Antennas •
Audio Formats: May be streamed in PCM or MP3, •
Uncompressed formats: (WAV, PCM), Compressed
formats: (MP3, AAC, MP2, WMA)
DLNA 1.5 and UPnP compliant and certified •
Controlled by either the IR Remote (DMRIR500) or •
the Controller – Wireless-N Touchscreen Remote
(DMWR1000)
Front Panel
Power (Blue/Orange) Pressing the Power
button toggles between Power on and
standby mode. Standby mode minimizes the
power consumed by your Player when not in
use. Standby mode allows you to power on
your unit using the remote control or power
button on the front panel.
To completely power off your Player,
disconnect the power from the device.
The LED light flashes blue while the device
is powering up and connecting to the
network. It will remain solid blue once the
device is connected to the network. When
the device is in standby mode, the LED will
appear orange. If the LED is red, there is an
issue with the device.
NOTE: Holding the Power button
for 15 seconds will restore factory
default settings.
WARNING: Restoring factory
default settings may revert to an
older version of the firmware. After
restoring the defaults, the firmware
can be updated manually or it
will be automatically updated if
autoupdates is selected.