User's Manual

Navigating the User Interface
10
Controller/Wireless-N Touchscreen Remote
Wireless Home Audio
NOTE: The wireless network name is
case-sensitive. Capital letters can be found
immediately after the group of lowercase
letters.
Once the wireless network name has been selected, a
screen will appear asking for the wireless security mode
utilized on the network.
Opens If your network doesn’t have wireless security
enabled, the open option should be selected.
NOTE: Linksys recommends using some form
of wireless security on your network to help
safeguard your personal information. Wireless
security is typically configured on your router.
Refer to the documentation included with your
router for details on enabling wireless security.
Shareds If your network uses WEP security, select
this option and enter in WEP key number 1. Enter the
appropriate number of hexadecimal characters (“0” to
“9” and “A” to “F”). For 64-bit encryption, enter exactly
10 hexadecimal characters. For 128-bit encryption,
enter exactly 26 hexadecimal characters.
WPAs Select TKIP or AES and enter the network’s
Passphrase (also called a pre-shared key) of 8-63
characters.
WP2s Select TKIP or AES and enter the network’s
Passphrase (also called a pre-shared key) of 8-63
characters.
Wi-Fi Protected Setup™ Discoverys This option is
used to connect to your router using the Wi-Fi Protected
Setup™
button on the Wireless Home Audio Director
and the Wi-Fi Protected Setup™
button on your
router..
Wi-Fi Protected Setup™ Pin Settings Select this
option to enter the Wireless Home Audio Director’s
PIN number on the router.
Advanced This option is used for IP configuration. A
dynamic or static IP address can be selected here.
Dynamic IPs The dynamic IP option should be selected
if your router or network connection automatically
provides an IP address to devices on the network.
Once this option is selected, the Details screen can be
used to verify that an IP address has been obtained.
Static IPs Selecting Static IP will prompt you to enter
the IP address. To enter the IP address using the
remote control, remove the existing address by using
the left arrow on the Navigation Halo. Numbers can be
entered manually using the keypad or arrow up and
down on the Navigation Halo to scroll through the
number selections. To move to the next digit, use the
right arrow on the Navigation Halo. To enter a dot (.)
or period in the IP address, press the zero (0) button
twice.
Details This option displays the current network
connection settings including the wireless network name,
wireless security type, DHCP status, IP address, subnet
mask, gateway, and DNS information.
Zones and Libraries
Rename Zone
Rediscover
General
Date Time Setup
Set Times Select the month, day, year, and enter the
time using the Navigation Halo.
Set Time Zones Select your local time zone.
Time Formats This allows you to select a 12 hour or
24 hour time format. The 12 hour format is the default
setting.
Date Formats Allows you to specify the order that the
day, month, and year are displayed.
NPS setup
This option configures the Now Playing Screen. This feature
can be configure to display the Now Playing Screen after
15, 30, or 60 seconds of playback. Off disables the feature.