User's Manual
Table Of Contents
- Product Overview
- Setting Up: Basics
- How to create a home network
- Where to find more help
- How to install your router
- How to configure your router
- How to test your Internet connection speed
- How to connect devices to your network
- How to set up parental controls
- How to configure your guest network
- How to back up your router configuration
- How to customize Linksys Smart Wi-Fi
- Using an External Drive
- Setting Up: Advanced
- How to manually set up your router
- How to associate a router with your Linksys Smart Wi-Fi account
- How to get the most out of your dual-band router
- How to control access to your network
- How to set up the DHCP server on your router
- How to access your network on the Internet
- How to clone a MAC address
- How to connect to your corporate office using a VPN
- How to optimize your router for gaming and voice
- How to enable Voice over IP on your network
- How to configure UPnP
- How to use a router as an access point
- How to put your new router behind an existing router
- How to expose a device to the Internet
- Port Forwarding and Port Triggering
- Maintaining and Monitoring
- Troubleshooting
- Specifications
39
Setting Up: Advanced
Linksys EA-Series
4.
At the end of setup, follow the on-screen instructions to set up your
Linksys Smart Wi-Fi account.
NOTE:
As part of the router setup process, you will be sent a verification
e-mail. From your home network, click the link in the e-mail to
associate your router with the Linksys Smart Wi-Fi account. Make
sure that the link opens in a supported web browser, such as
Internet Explorer 8 or higher, Firefox 8 or higher, Google Chrome 10
or higher, and Safari 5 (for Mac) or higher.
To share an Internet connection
NOTE
This is a complex process, so this procedure assumes that you have
some networking knowledge.
To add another router to share an Internet connection:
This topic covers cases one and two above
1.
Determine the IP address range for your upstream (office or building)
network.
To determine the address range by using a Windows computer:
a.
Connect your computer into your upstream network’s router.
b.
Click Start, Run, type CMD, then click OK. The command prompt
window appears.
c.
Type ipconfig, then press Enter.
TIP
Although you can determine your computer’s IP address in
many ways, this method is quick and relatively easy.
d.
Take note of the IP address. In this example, the IP address is
192.168.100.192.
To determine the address range by using a Mac computer:
a.
Connect your computer into your upstream network’s router.
b.
From the Dock, click System preferences, click Network, then click
Ethernet in the window to the left. A network status window opens.
c.
Take note of the IP address. In this example, the IP address is
192.168.100.139.
Example: The above examples show that upstream IP addresses are on
the 192.168.100.0 network. (The “0” indicates the entire network.) Your
upstream network’s address may be different. The default address of
your new Linksys router is 192.168.1.1. In setting up one router behind
another, you must make sure that the local network on your new router is
different than the network of your upstream router. In the above example,
because the default local network on your Linksys router 192.168.1.0 is
on a different subnet than the office network’s 192.168.100.0, you will be
able to place your Linksys router behind the other router.